Introduction: On-chip integrated circuits often need to be tunable to correct for process or temperature variations. However, unpredictable or unknown device characteristics make it hard to implement tunable linear circuits. In modern submicron CMOS technologies, the transistor characteristics can deviate significantly from the ideal behaviour. In this Letter a continuously tunable current divi...

Floating-point division is generally regarded as a low frequency, high latency operation in typical floating-point applications.So due to this not much development had taken place in this field. But nowadays floating point divider has become indispensable and increasingly important in many modern applications. Most of the previous implementation required much larger area and latencies. In this ...

The report describes the methods used and results of a characterization of the voltage non-linearity of a 1200 kV HVDC divider at Aalto University high voltage laboratory. Measurements were performed in April 2012 and June 2013. Historical data from 1990 and 2007 were combined with new measurement results to gain good understanding of the voltage dependence and its reasons. The new more precise...

A 6.0-13.5 GHz Alias-Locked Loop (ALL) frequency synthesizer is designed and simulated in 130 nm CMOS. Using an aliasing divider, the ALL architecture makes it possible to create high-speed frequency synthesis circuits without relying on a traditional divider clocked at fV CO in the feedback path. In this implementation, a new architecture of high frequency ring oscillator is proposed with a fe...

A unequal Wilkinson power divider based on asymmetrical coupled line section is presented in this paper. The proposed unequal Wilkinson power divider topology uses asymmetrical coupled-line section and two transmission-line transformers. For simplification, a section asymmetrical coupled line is applied to obtain front compact matching structure. For generalization, three ports terminated imped...

This paper presents an unequal Wilkinson power divider operating at arbitrary dual band without reactive components(such as inductors and capacitors). To satisfy the unequal characteristic, a novel structure is proposed with two groups of transmission lines and two parallel stubs. Closed-form equations containing all parameters of this structure are derived based on circuit theory and transmiss...

We present an optical frequency divider based on a 200 MHz repetition rate Er:fiber mode-locked laser that, when locked to a stable optical frequency reference, generates microwave signals with absolute phase noise that is equal to or better than cryogenic microwave oscillators. At 1 Hz offset from a 10 GHz carrier, the phase noise is below -100 dBc/Hz, limited by the optical reference. For off...

The impact of a series resistor (R(S)) on the variability and endurance performance of memristor was studied in the TaO(x) memristive system. A dynamic voltage divider between the R(S) and memristor during both the set and the reset switching cycles can suppress the inherent irregularity of the voltage dropped on the memristor, resulting in a greatly reduced switching variability. By selecting ...

This paper presents a high-throughput fixed-point complex divider which uses four pipelined CORDIC units to transform and divide complex numbers in Polar coordinates. By persevering the macro-angle for CORDIC rotations in redundant form and developing an optimized pipelining structure, the FPGA based implementation achieves a 9× advantage on throughput over the best design reported. In addition...

In this paper, a new kind of 3D transition and power divider based on half mode substrate integrated circular cavity (HSICC) is proposed. This novel HSICC transition and power divider can be easily integrated into microwave and millimeter-wave multilayer circuits using LTCC technology. What is more, it can reduce nearly half size of normal SICC resonator and has the advantages of high flexibili...