The present study evaluated the effect of repeated simulated microwave disinfection on physical and mechanical properties of Clássico, Onda-Cryl and QC-20 denture base acrylic resins. Aluminum patterns were included in metallic or plastic flasks with dental stone following the traditional packing method. The powder/liquid mixing ratio was established according to the manufacturer's instructions...

materials used in the body, especially the materials used in various oral cavity regions should be stable and passive without any interactions with the body tissues or fluids. dental amalgam, c omposite resins and dental cements are the materials of choice with such properties. the first attempts to produce active materials, which could interact with the human body tissues and fluids were promp...

introduction: this in vitro study evaluated the influence of composite thickness (with or without fiber reinforcement) on fracture resistance of direct restorations in endodontically treated teeth. methods and materials: fifty-six intact human premolars were chosen and randomly divided into four groups ( n =14). after preparation of a mesio-occluso-distal (mod) cavities and cusp reduction, the ...

This study evaluated the effect of microwave energy on the hardness, impact strength and flexural strength of the Clássico, Onda-Cryl and QC-20 acrylic resins. Aluminum die were embedded in metallic or plastic flasks with type III dental stone, in accordance with the traditional packing technique. A mixing powder/liquid ratio was used according to the manufacturer's instructions. After polymeri...

background: repair bond strength of different composite resins has been assessed in few studies. in addition, reports on the effi cacy of surface treatments are debated. therefore, this in vitro study was conducted to evaluate the effect of three surface treatments on two nanocomposites versus a microhybrid composite. materials and methods: in this experimental study, 135 composite blocks (45 s...

Three isomers of methacryloyloxyethyl naphthalenetricarboxylate anhydrides (MENTA-126, -236 and -184) were synthesized, and their adhesiveness to teeth and non-precious dental alloys was investigated. The MENTA resins initiated by TBB-O showed about 12-13MPa of the bond strength on treated enamel and 10-12.5MPa on treated dentin after 120 thermocycles, while, after the equal thermal cyclings, t...

In this study, a novel dental composite based on the unsaturated bismethylene spiroorthocarbonate expanding monomer 3,9-dimethylene-1,3,5,7-tetraoxa-spiro[5,5]undecane (BMSOC) and bisphenol-S-bis(3-meth acrylate-2-hydroxypropyl)ether (BisS-GMA) was prepared. CQ (camphorquinone) of 1 wt % and DMAEMA (2-(dimethylamino)ethyl methacrylate) of 2 wt % were used in a photoinitiation system to initiate...

Adhesion of Candida albicans to acrylic of dental prostheses or to salivary macromolecules adsorbed on their surface is believed to be a critical event in the development of denture stomatitis. In previous studies our group has shown that adhesion of C. albicans germ tubes to polystyrene is decreased by saliva whereas C. albicans yeast cells adhesion to the same material is enhanced. The result...

Single visit reconstruction of the fractured crown can be completed with composite resins if there is no bleeding due to the soft tissue injury. Clinical inspection revealed a complex crown fracture of the central incisor as well as a simple horizontal fracture of the lateral incisor crown of the enamel-dentin type. Vertical fracture separated the palatal enamel wall from the rest of the latera...

Bond strengths of bonded composite resins to tooth substrates vary depending on when they were measured. Most bond strengths reported in the literature are a result of one hour, 24-hour, or longer periods of time that do not simulate actual clinical practice when occlusal adjustment and finishing and polishing procedures are performed within seconds after restoration placement. There are many d...