In order to study the initial corrosive changes of dental casting alloys in the mouth, the condition and composition of the proximal surface of the class II inlay were analyzed by the scanning electron microscope (SEM) and the electron probe microanalyser (EPMA). These analyses on the same small areas of the proximal surface were carried out every week for four weeks. The results were compared ...

The electrochemical behaviors of eight parent alloys and four post-solder alloys used in dental prostheses were specified in a (pH=7.4; [NaCl]=9g/L)-aqueous solution at 37°C. For each alloy, the free potential was followed during two hours, and a cyclic polarization between the cathodic domain and the solvent’s oxidation was performed. The galvanic corrosion between each parent alloy and its us...

OBJECTIVES The aims of this study were to quantify the metallic ions released by various dental alloys subjected to a continuous flow of saliva and to estimate the nutritional and toxicological implications of such a release. METHODS Four pieces of three nickel-based, one noble, one high-noble and two copper-aluminum alloys were cast and then immersed in a continuous flow of artificial saliva...

The effect of 5 different surface conditioning methods on bonding of metal brackets to cast dental alloys was examined. The surface conditioning methods were fine (30-microm) or rough (125-microm) diamond bur, sandblasting (50-microm or 110-microm aluminum oxide [Al2O3]), and silica coating (30-microm silica). Fifty disc-shaped specimens of 5 different alloys (gold-silver, palladium-silver, nic...

In a recent article [Opt. Lett.34, 2507 (2009)], the authors concluded that the imaginary part of the complex conductivity sigma of an AlInN film was negative. However, this result was obtained using an approximation that is not applicable in this case. Using the correct equation, the data can be well described with a positive imaginary part of sigma.

The metals for porcelain fusing used in this study were gold alloys and nickel-chromium alloys. Chromatic characteristics were compared between samples of 0.1, 0.2 and 0.3 mm thickness. The dentin porcelain was fused on the opaque surface. Chromatic analyses were then carried out at each stage of 0.1 mm-incremental reductions of the dentin thickness starting from 0.5 mm. In conclusion, the meta...

Surface nanocrystallization using a surface mechanical attrition treatment effectively activates the surface of magnesium alloys due to the increase in grain boundary diffusion channels. As a result, the temperature of subsequent surface alloying treatment of pure Mg and AZ91 alloy can be reduced from 430 degrees C to 380 degrees C. Thus, it is possible to combine the surface alloying process w...

INCONEL alloy 783 was annealed and aged following the standard heat treatment procedure. One set of specimens was then isothermally exposed at 500 degrees C for 3000 h. Mechanical properties were measured at room temperature and 650 degrees C, and the results showed the prolonged exposure increased the strength and decreased elongation of alloy 783. The microstructures of as-produced and expose...

für Naturforschung in cooperation with the Max Planck Society for the Advancement of Science under a Creative Commons Attribution 4.0 International License. Dieses Werk wurde im Jahr 2013 vom Verlag Zeitschrift für Naturforschung in Zusammenarbeit mit der Max-Planck-Gesellschaft zur Förderung der Wissenschaften e.V. digitalisiert und unter folgender Lizenz veröffentlicht: Creative Commons Namen...

The dislocation velocities and mechanical strength of bulk crystals of Ge1ÿxSix alloys have been investigated by the etch pit technique and compressive deformation tests, respectively. The velocity of dislocations has been determined as a function of stress and temperature in the composition ranges 0 < x < 0:08 and 0:94 < x < 1. In the composition range 0 < x < 1 the yield stress showed a maxim...