Through its ‘Column Targeting Tools’ the Aspen plus simulator performs the ‘Thermal Analysis’ for rigorous column (RadFrac) calculations and produce Column Grand Composite Curves (CGCC) and exergy loss profiles. The CGCC displays the net enthalpies for the actual and ideal operations at each stage, and the cold and hot heat utility requirements, while the exergy loss profiles indicate the level...

For many countries, increasing energy efficiency and reducing greenhouse gas emissions are key countermeasures to cope with the energy crisis and climate change. Of the various heating equipment such as heat pumps, gas-fired boilers, oil-fired boilers, or electric boilers, heat pumps are widely adopted for space heating, water heating, and process heating by households, business, and industry d...

Although water-cooled chillers are more energy efficient than air-cooled chillers, a majority of chilled water systems use air-cooled chillers. In cold weather climates, air-cooled chillers are capable of functioning in low ambient temperatures with few operational concerns, where as water-cooled chiller systems must be equipped to prevent cooling tower freezing. The integrated chiller system a...

Flat tube heat exchangers with louvered fins were applied in order to meet the performance requirements and compactness in automotive air conditioning systems. Experimental and simulation study focusing on the air side thermal hydraulic performance of automotive heat exchangers were performed in this article. Test results showed that the heat capacity of a condenser with 5.4 mm height louvered ...

As part of a preliminary hazard analysis for a new phenol plant, the results of a hazard and operability study (HAZOP) conducted in the initial stages of the project design were re-evaluated due mechanical failure detected during the test operation. Out of the possible mechanical defects for the crude phenol column (CPC), the fact that the lowest risk grade was given to the column without consi...

A planar, silicon mini capillary pumped loop (CPL) was designed, built, and tested using recent MEMS technology to provide integral cooling and temperature control for electronics. This design featured three silicon fusion bonded wafers incorporating an evaporator, condenser, liquid line and vapor line, all of which were dry plasma etched. Grooves were etched in the condenser and evaporator to ...

A free-field (FF) substitution method for calibrating the pressure sensitivity of microphones at frequencies up to 80 kHz is demonstrated with both grazing and normal-incidence geometries. The substitution-based method, as opposed to a simultaneous method, avoids problems associated with the nonuniformity of the sound field and, as applied here, uses a 1/4-in. air-condenser pressure microphone ...

Mechanically refrigerated test chambers are classified as either single stage low (-40 °C) or cascade ultralow (-70 °C) temperature systems. While cascade systems are reliable and versatile, the potential for leakage between stages within a cascade heat exchanger remains. Further, the need for two compressors and increased control mechanisms can make the system more and more complex. The only m...

Fast and accurate transient response is the main requirement in electric machine position control. Conventional cascade control structure has sluggish response due to the limitation of inner control loop bandwidth. In this paper, in order to decrease the Permanent Magnet Synchronous Motor (PMSM) transient response time it can be used reference model using feed-forward signals. In this structure...

The ball and beam system is one of the most popular laboratory setups for control education. In this paper, we design a fuzzy PD cascade controller for a ball and beam system using Asexual Reproduction Optimization (ARO) technique. The ball & beam system consists of a servo motor, a grooved beam, and a rolling ball. This system utilizes a servo motor to control ball’s position on the beam. Chan...