No reports have described experiments designed to determine the strength characteristics of spinal nerve roots and rami radiculares for the purpose of explaining the complexity of symptoms of medullary cone lesions and cauda equina syndrome. In this study, to explain the pathogenesis of cauda equina syndrome, monoaxial tensile tests were performed to determine the strength characteristics of sp...

The inherent strength of individual carbon nanotubes (CNTs) offers considerable opportunity for the development of advanced, lightweight composite structures. Recent work in the fabrication and application of CNT forms such as yarns and sheets has addressed early nanocomposite limitations with respect to nanotube dispersion and loading and has pushed the technology toward structural composite a...

This study evaluated the tensile and flexural strength of tungsten inert gas (TIG) welds in specimens made of commercially pure titanium (CP Ti) compared with laser welds. Sixty cylindrical specimens (2 mm diameter x 55 mm thick) were randomly assigned to 3 groups for each test (n=10): no welding (control), TIG welding (10 V, 36 A, 8 s) and Nd:YAG laser welding (380 V, 8 ms). The specimens were...

introduction: laser tissue soldering using albumin and indocyanine green dye (icg) is an effective technique utilized in various surgical procedures. the purpose of this study was to perform laser soldering of rat skin under a feedback control system and compare the results with those obtained using standard sutures. material and methods: skin incisions were made over eight rats’ dorsa, which w...

Strength of rocks in the confined tension region, where minimum principal stress is tensile, has only infrequently been measured and not well understood. Quasi-static Brazilian tests under a range confining stresses (2.76 to 27.58 MPa) used determine strength sandstone region. The test results indicate that region was strong function intermediate stress: increasing significantly increased sands...

Polymer-based nanocomposites due to their advantages such as corrosion resistance,adequate mechanical properties and low cost are widely used in modern technologies. The increasing application of these nanocomposites, and hence their welding seems unavoidable. In this paper, a novel hottool in friction stir welding process is used for butt welding nanocomposite plates of 5 mm thick containing p...

Glycyrrhiza glabra extract is gaining increasing acceptance as a folk remedy for treatment of wound. We studied the effect of its extract on wound tensile strength in albino rats. 20 male albino rats had a linear 3 cm incision made over skin of back. The animals were randomly divided into two experimental groups, as control and treatment. Animals of control group received topical cold cream onc...

in this research formability behavior and texture of st14 low carbon steels produced by foolad mobarakeh plant for deep drawing application had been studied. plate textures were characterized by x-ray diffraction technique. to evaluate formability behavior one dimensional tensile test was carried out and related parameters were recognized. moreover eriksson experiment and spherical pattern prin...

Polyamide 6 / nitrile butadiene rubber / nanoclay (PA6/NBR/clay) nanocomposite has gathered wide acceptance in industry. Laser welding, as a fabrication method, is applied to welding of polymer nanocomposites. In this study, the input parameters (clay (Closite 30B) content, laser power, scan velocity and stand-off-distance) are varied to achieve the best responses (tensile strength of welds). R...

The dynamic characterization of concrete is fundamental to understand the material behavior in case of heavy earthquakes and dynamic events. The implementation of material constitutive law is of capital importance for the numerical simulation of the dynamic processes as those caused by earthquakes. Splitting tensile concrete specimens were tested at strain rates of 10(-7) s(-1) to 10(-4) s(-1) ...