The objective of this study was to investigate the rebonding effect of a new silane coupling agent on various ceramic brackets bonded to ceramic specimen. Different ceramic brackets (Fascination 2, Clarity SL, and In-OvationC) were assigned to three groups: rebonding with new silane coupling agent, rebonding with conventional silane coupling agent, or regular bonding as control (n = 16). Bracke...

Introduction Several attempts have been made to develop ceramic systems without metal frameworks. To date, there is an increasing range of dental ceramics allowing clinicians to combine very good esthetics with optimal mechanical properties, such as glass-infiltrated porcelain, aluminaand zirconia-reinforced ceramics . Several authors have described different surface treatments to improve the a...

The ability to pattern ceramic materials in three dimensions (3D) is critical for structural, functional, and biomedical applications. One facile approach is direct ink writing (DIW), in which 3D structures are built layer-by-layer through the deposition of colloidalor polymer-based inks. This approach allows one to design and rapidly fabricate ceramic materials in complex 3D shapes without the...

Introduction and Summary Over the past year, ISEN funding has been utilized to make significant research progress towards the fabrication of a fully 3D-printed iron/solid oxide fuel cell (Metallic/multi-ceramic) batterygenerator system (Figure 1). Monies have gone towards the partial funding of one grad student/postdoc, Adam Jakus, in Ramille Shah’s Tissue Engineering and Additive Manufacturing...

This is a review article covering literature reported on consolidation of ceramic components out of aq.-based Al2O3, MgAl2O4 spinel, β-Si4Al2O2N6, β-SiAlON-SiO2 composite, and zirconia toughened alumina (ZTA) slurries following hydrolysis induced aq. gelcasting (henceforth referred to as GCHAS) route. GCHAS is a combination of aq. gelcasting (GC) and hydrolysis assisted solidification (HAS) rou...

OBJECTIVE To compare different surface treatments of lithium disilicate-based ceramic on bond strengths to composite. METHODS Lithium disilicate-based ceramic microbars (1 mm × 1 mm × 6 mm) were produced and abraded using diamond (D) or CoJet sandblasting (C), etched using phosphoric acid (P) or hydrofluoric acid (H) and silanised (S). A total of 12 surface treatments were adopted: D, DP, DH,...

In this research study, the effects of aluminum nitride (AlN) additive on the densification behavior and microstructure development of titanium diboride (TiB2) based ceramic matrix composite were investigated. In this way, a monolithic TiB2 ceramic and a TiB2–5 wt% AlN ultrahigh temperature ceramic composite were fabricated by spark plasma sintering (SPS) proces...

BACKGROUND Few large series of hard bearing surfaces have reported on reasons for early failure. A number of unique mechanisms of failure, including fracture, squeaking, and adverse tissue reactions, have been reported with these hard bearing surfaces. However, the incidence varies among the published studies. QUESTIONS/PURPOSES To confirm the incidences, we identified the etiologies of early...

This study examines the effects of different ZrB2 content on various mechanical properties and electrical conductivity of ZrB2/Y-TZP composite. Composites with ZrB2 content of up to 20 wt-% were particularly beneficial at the lower sintering temperature range by achieving greater densification and better hardness than Y-TZP monolith. In contrast to the trends estimated from rule of mixture, the...