Hardness of the widely used structural steel is of vital importance since it may help in the determination of many mechanical properties of a material under loading situations. In order to obtain reliable information for design, properties homogeneity should be validated. In the current study the hardness variation over the different diameters of the same AISI 4140 bar is investigated. Measurem...

To upgrade the performance of welded joints the various improvement methods are used. Shot peening is one of the improvement method used to strengthen the properties of welded joints. GMAW process is very well suited for welding of AISI 304 austenitic stainless steels. Regression analysis is the statistical modeling technique, and it is suitable for the majority of predicting problems. It is va...

In this study, the effects of cutting edge geometry, workpiece hardness, feed rate and cutting speed on surface roughness and resultant forces in the finish hard turning of AISI H13 steel were experimentally investigated. Cubic boron nitrite inserts with two distinct edge preparations and throughhardened AISI H13 steel bars were used. Four-factor (hardness, edge geometry, feed rate and cutting ...

The lifetime of structural components of spallation targets (beam window, liquid metal container, return hull) is determined by the irradiation-induced changes of the mechanical properties of their materials. An extensive test program was initiated using specimens obtained from spent target components from operating spallation facilities (Los Alamos Neutron Science Center, LANSCE and the Spalla...

In this present work, the effect of input parameters viz. grinding wheel speed, work-piece speed, abrasive grain size, depth of cut, concentration of cutting fluid, and number of passes has been found on the out-ofroundness of cylindrical grinded AISI 4140 steel. Out-of-roundness is of great importance in case of shafts, axles, pistons, piston pins, crankshafts, roller bearings as out of roundn...

In addition to the bulk properties of a workpiece material, characteristics of the tribofilms formed as a result of workpiece material mass transfer to the friction surface play a significant role in friction control. This is especially true in cutting of hardened materials, where it is very difficult to use liquid based lubricants. To better understand wear performance and the formation of ben...

High speed machining (HSM) may produces parts with substantially higher fatigue strength; increased subsurface micro-hardness and plastic deformation, mostly due to the ploughing of the round cutting tool edge associated with induced stresses, and can have far more superior surface properties than surfaces generated by grinding and polishing. Cutting edge roundness may induce stress and tempera...

This paper presents an investigation of non-stationary induction heating process applied to AISI 4340 steel spline shafts based on 3D simulation and experimental validation. The study is based on the knowledge, concerning the form of correlations between various induction heating parameters and the final hardness profile, developed in the case of stationary induction heating. The proposed appro...