In this paper, a low voltage dual-pulse-clock double edge triggered D'flip-flop (DPDET) is proposed. The DPDET flip-flop uses a split output latch clocked by a short pulse train. Compared to the previously reported double edge triggered flip-flops, the DPDET flip-flop uses only six transistors with two transistors being clocked, operating correctly under low supply voltage. The total transistor...

This paper describes high-voltage CMOS buffer architecture that uses low-voltage transistors. The voltage capability of presented architecture is nearly three times larger than the voltage capability of used MOSFET's. This buffer topology could be used to provide 3.3V compatibility of 1.2V and 1.5V digital ICs implemented in standard CMOS technology. A 7V circuit-prototype was fabricated in 0.2...

supply voltage system where low supply gates may feed into high supply gates energy savings for benchmark circuits in comparison when level converters are not allowed. of a level shifter circuit having a structure to reduce fall and rise. input voltage levels prohibit the use of direct-gate drive circuits for high-side signal are linked by a level shift circuit that must tolerate the high-volta...

This paper describes the impact of crosstalk noise on low power design techniques based on voltage scaling. I t is shown that this power saving strategy aggmvates the crosstalk noise problem and reduces circuit noise immunity. A new energy-eficient, noise-tolerant dynamic circuit technique is presented to address this problem. In a 0.35pm CMOS technology and at a given supply voltage, the propo...

supply voltage system where low supply gates may feed into high supply gates energy savings for benchmark circuits in comparison when level converters are not allowed. of a level shifter circuit having a structure to reduce fall and rise. input voltage levels prohibit the use of direct-gate drive circuits for high-side signal are linked by a level shift circuit that must tolerate the high-volta...

Introduction At the heart of automotive design is the requirement to pass Electro-Magnetic Compatibility (EMC) limits, by minimising conducted and radiated emissions and susceptibility. The use of Switched Mode Power Supplies (SMPS) is now common-place, yet a prime source of electro-magnetic emissions. Minimising these emissions is a key goal of SMPS design. Use of spread spectrum techniques is...

The neutral beam injection generate ultra-high temperature energy in the tokamak of nuclear fusion. The neutral beam injection make up arc power supply, filament power supply and acceleration & deceleration power supply. The arc power supply has characteristics of low voltage and high current. Arc power supply generate arc through constant output of voltage and current. So this paper proposed s...