In rock drilling, bit wear is a major factor in determining bit life, the cost of drilling and may significantly influence the drilling method selected for given rock type. Effective control of bit wear can yield significant cost savings. Prediction of cuttability or drillability requires an understanding of the cutting action and the mode of wear and their interaction with the rock propertiesW...

The role of friction in the functional performance of biomaterial interfaces is widely reckoned to be critical and complicated but poorly understood. To better understand friction forces, we investigated the natural adaptation of the holdfast or byssus of mussels that live in high-energy surf habitats. As the outermost covering of the byssus, the cuticle deserves particular attention for its ad...

This paper presents the wear characteristics of the composite ceramic coating made with Al2O3-40wt%8YSZ on the biomedical grade Ti-6Al-4V alloy (grade 5) used for total joint prosthetic components, with the aim of improving their tribological behavior. The coatings were deposited using a plasma spraying technique, and optimization of plasma parameters was performed using response surface method...

A study has been carried out to investigate the influence of soot contaminated automotive lubricants in the wear process of a simulated engine valve train contact. Previous research on this topic has been mainly performed from a chemical point of view in fundamental studies, with insufficient relevance to real engine conditions i.e. load and geometry. This study investigates the conditions unde...

With the rapid development of high-precision-device technology, new demands are put forward for micro milling. The size effect and low cutting energy milling make process expensive difficult, especially Ti-6Al-4V alloys. wear micro-milling cutter lacks corresponding international standards its mechanism is complex. In this paper, four kinds cutters with different states were obtained by designi...

As a result of its widespread and pervasive economic consequences wear, the almost inevitable companion of friction, has been the subject of much scientific and empirical investigation; the literature is rich with ‘wear equations’ so that, on occasion, the practitioner can seem to have too much information rather than too little. Some guidance and reconciliation between analytical and computati...

A cold sprayed Al coating on S355 structural steel was processed using a laser remelting (LR). The surface and cross-section morphologies, chemical compositions, and phases of as-obtained Al coating before and after LR were analyzed using a scanning electronic microscope (SEM), energy dispersive spectrometer (EDS), and X-ray diffractometer (XRD), respectively, and their hardness was measured us...

Background and purpose - Severe backside wear, observed in older generations of total knee replacements (TKRs), led to redesign of locking mechanisms to reduce micromotions between tibial tray and inlay. Since little is known about whether this effectively reduces backside wear in modern designs, we examined backside damage in retrievals of various contemporary fixed-bearing TKRs. Patients and ...