Line-commutated converter-voltage source converter (LCC-VSC) power transmission technology does not have the problem of communication failure very usually. It therefore can support long-distance, long-capacity electric energy. However, factors such as topology, control strategy, and short-circuit capacities make traditional protection principles fully applicable to LCC-VSC hybrid systems. To en...

The STATCOM (Synchronous Static Compensator) based on voltage source converter (VSC) is used for voltage regulation in transmission and distribution systems. The STATCOM can rapidly supply dynamic VARs required during system faults for voltage support. The apparent impedance is influenced by the reactive power injected or absorbed by the STATCOM, which will result in the under reaching or over ...

An integral plus resonant sliding mode direct power control (IRSMC DPC) strategy for voltage source converter high voltage direct current (VSC-HVDC) systems under unbalanced grid voltage conditions is proposed in this paper. Through detailed instantaneous power flow analysis, a generalized power compensation method, by which the ratio between the amplitude of active and reactive power ripples c...

A battery Energy storage system (BESS) based voltage and frequency controller (VFC), for an Autonomous Asynchronous Generator (ASG) driven by an uncontrolled pico hydro turbine used in constant power mode, is presented in this paper. Excitation of the asynchronous generator with capacitor bank enables it to generate rated voltage at no load. The additional reactive power demand of the ASG on lo...

The SVC (Static Var Compensator) based on voltage source converter (VSC) is used for voltage regulation in transmission and distribution system. The SVC can rapidly supply dynamic VARs required during system faults for voltage support. The apparent impedance is influenced by the reactive power injected or absorbed by the SVC, which will result in the under reaching or over reaching of distance ...

Abstract This study focuses on stability of weak grid connected voltage source converter (WG‐VSC) in Low‐frequency mode (LFM) (around 1–10 Hz), which is dominated by interactions among phase‐locked loop (PLL), outer control and condition. In order to clearly reveal LFM mechanism WG‐VSC, a simple but effective PLL‐equivalent model has been proposed. First, generic small signal consisted PLL ‘out...

DC distribution networks are low-inertia systems with a range of uncertainties and disturbances. The traditional droop control widely used in has contradiction between the accurate power sharing units voltage deviation due to presence line impedance. To overcome this enhance immunity tracking performance voltage-source converter (VSC) current inner loop PI control, paper proposes coordinated vo...

When the direct current circuit breaker (DCCB) fails to operate, fault range will further expand, endangering safe operation of power gird. Therefore, this study proposes a DCCB failure protection method and secondary accelerated isolation scheme voltage source converter-based high-voltage (VSC-HVDC) grids. On basis considering influence disconnection, characteristics after are analyzed, based ...

This paper, presents a new unified powerquality conditioning system (MC-UPQC) , The response of the Multi converter unified power quality conditioner, for different types of controllers are studied. This paper capable of simultaneous compensation for voltage and current in multibus/multifeeder systems. In this configuration, one shunt voltage-source converter (shunt VSC) and two or more series ...

A non-isolated DC/DC converter with high transfer gain is proposed in this paper. The presented converter consists of the switched inductor and three-level converters. The DC/DC power converter is three-level boost converter to convert the output voltage of the DC source into two voltage sources. The main advantages of DC/DC converter are using low voltage semiconductors and high gain voltage. ...