The fibers extracted from the piassava palm tree, scientifically known as Attalea funifera, are among the stiffest lignocellulosic fibers being considered for polymer composite reinforcement. Characterization of piassava composites have been carried out for different polymeric matrices and mechanical tests. In this work the tensile properties of DGEBA/TETA epoxy matrix composites reinforced wit...

Tensile properties on ASTM A216 WCB cast steel with centerline porosity defect were studied with radiographic mapping and finite element remodeling technique. Non-linear elastic and plastic behaviors dependent on porosity were mathematically described by relevant equation sets. According to the ASTM E8 tensile test standard, matrix and defect specimens were machined into two categories by two t...

Single crystal specimens of Fe-17 at. % Ga were tested in tension at room temperature. Specimens with a tensile axis orientation of [110] displayed slip lines on the specimen faces corresponding to slip on the {110}with a critical resolved shear stress of 220 MPa. Yielding began at 0.3% elongation and 450 MPa. An ultimate tensile strength of 580 MPa was observed with no fracture occurring throu...

arch dams are generally built in cantilvever monoliths. vertical contraction joints between monoliths control the stresses due to concrete shrinkage and temperature variations. past studies in earthquake safety evaluation of the system often show the tensile fracture and local nonlinear deformation of joints. in this paper, some nonlinear joint element constitutive models are presented to exami...

A 2D, hexagonal in geometry, statistical model of fracture is proposed. The model is based on the drying fracture process of the bamboo Guadua angustifolia. A network of flexible cells are joined by brittle junctures of fixed Young moduli that break at a certain thresholds in tensile force. The system is solved by means of the Finite Element Method (FEM). The distribution of avalanche breakings...

Poly lactic acid (PLA) is widely used for the manufacture of biodegradable stents (BDSs). It was observed and investigated that tensile loads can significantly affect the degradation rate of PLA in our previous study. Additionally, non-uniform degradation can arise from complicated stress distributions in implanted stents under long-term and pulsatile tensile loading. The objective of this work...

The use of porous blocks is limited, however, because hydroxyapatite has only modest tensile strength and a low fracture toughness, leaving it susceptible to fracture or fragmentation if subjected to mechanical loading. Incorporating hydroxyapatite granules into a biocompatible polymeric matrix produces a more robust material. Judicious selection of the loading level of the HA allows for a high...

Assessment of the correlation between rock brittleness and rock fracture toughness has been the subject of extensive research works in the recent years. Unfortunately, the brittleness measurement methods have not yet been standardized, and rock fracture toughness cannot be estimated satisfactorily by the proposed indices. In the present study, statistical analyses are performed on some data col...

the effects of isothermal aging at temperatures between 550-850 ?c for durations of 1-100 h on microstructure, tensile properties, and impact fracture behavior of 316l austenitic stainless steel weld metal have been investigated. for this purpose, various techniques including metallographic observations, measurement of ferrite content using ferritscope, and fractographic investigations have bee...