Abatraet-constraints on diffusive creep cavity growth along grain boundary facets are studied for the limiting case when all facets oriented approximately normal to an applied tensik load am uniformly cavitated. This situation represents the opposite limiting case to when cavitated facets are we&sepamted and do not intemct with each other. The analysis is done for a 3-D periodic polycrystallii ...

Modelling fuel behaviour requires an accurate description of the cladding stress response for both operational and safety considerations. The transient creep response of Zirconium alloys is commonly modelled using a strain hardening rule which is known to hold in cases with monotonously increasing stresses. However, the strain hardening rule is experimentally known to fail in scenarios such as ...

Abstract This paper presented a high-temperature furnace with double electric stove wires for the test of creep rupture, adopted 5 mm wire in diameter, and are made up working alternate wire. When tester system detects is fractured, it will automatically quickly switch power supply circuit from to Then starts heat keep working, reducing loss caused by interruption on account fractured Experimen...

The compressive creep and recovery of foam earplugs was studied at various applied stresses leading to different fi nal creep strains. Deformation was determined from digital videos of the earplugs via image processing software. Creep could not be modeled by a single exponential in time; creep approximated a power law in time. Nonlinear viscoelasticity was observed: creep compliance depends on ...

Time-dependent creep analysis is presented for the calculation of stresses and displacements of axisymmetric thick-walled cylindrical pressure vessels made of functionally graded material (FGM). For the purpose of time-dependent stress analysis in an FGM pressure vessel, material creep behavior and the solutions of the stresses at a time equal to zero (i.e. the initial stress state) are needed....

Creep polycrystalline ice samples antifreeze glycopeptides re-accelerating or tertiary samples. Previous work grain-boundary migration consistent with this, as nucleation and growth of curves containing (AFGPs) creep that has shown obtained from the low concentrations of do not show the is found in pure ice that AFGPs inhibit in ice and the present results are tertiary creep is associated with ...

Background—The creep-fatigue properties of stainless steel 316 are of interest because of the wide use of this material in demanding service environments, such as the nuclear industry. Need—A number of models exist to describe creep-fatigue behaviours, but they are limited by the need to obtain specialized coefficients from a large number of experiments, which are time-consuming and expensive. ...

In the pressure vessel and piping and power industries, creep deformation has continued to be an important design consideration. Directionally solidified components have become commonplace. Creep deformation and damage is a common source of component failure. A considerable effort has gone into the study and development of constitutive models to account for such behavior. Creep deformation can ...