Multi-Walled Carbon Nanotubes (MWCNTs) surfaces were serially modified by the annealing treatment under Helium flow at 1000oC, the nitric acid treatment and again the annealing treatment under same conditions and their maximum adsorption capacities for benzene and toluene were measured and analyzed. The unmodified and modified MWCNTs werecharacterized by Fourier Tr...

Abstract In this investigation, surface modification toughening of partially stabilized zirconia ceramics, by sub-eutectoid solution annealing, has been performed. The Zr 0.918 Mg 0.068 Y 0.014 O 1.925 designated (MZY) was prepared mixing Magnesia Partially Stabilized Zirconia (MZ9) and Yttria Tetragonal (TZ3Y) Polycrystal commercial powders using wet ball milling. mechanical properties microst...

Gas atomized Nd-Fe-B powders of several compositions were separated in different size fractions by sieving. These annealed between 1100 °C and 1150 for 24 96 h. The oxygen content the was measured before after annealing fractions. concentration depends strongly on particle increases significantly during annealing, particularly case small sizes. effect microstructural changes analyzed detail, gr...

Sintering parameters of the SS316L water atomised inject ion moulded compact has been optimized for its best sintered density. The L9 (3 4 ) Taguchi orthogonal array is used in the experiment while sintering temperature, sintering time, heating rate and coofing rate was selected as factors that influenced the sintered density. The sintering environment was in the vacuum and four replications we...

This work presents the mathematic models of the basic processes from an iron ore processing plant. Based on the mathematic models, using the Matlab/Simulink platform, it was achieved the simulation of the dosing process and simulation of the sintering process. The achieved mathematic model allows the determination of the material flows in the charge at their chemical composition variation, or a...

Low-melting H3BO3, acting as sintering aid, was used to reduce the sintering temperature of 5 wt.% CaTiO3-doped (Zn0.65Mg0.35)TiO3 ceramics. The sintering behaviors, microstructures and microwave dielectric properties with different amounts of H3BO3 addition were investigated. The results showed that H3BO3 additive was very effective for lowering the sintering temperature and improving the bulk...

Spark-Plasma-Sintering (SPS) compaction experiments of nanostructured titanium carbonitride powders have been performed at 1600°C and 1800°C (sintering time = 1 min). The as-received nanostructured samples have been synthesized by rapid condensation from the gas-phase (high frequency plasma). The sintering results were compared with data obtained by various conventional sintering techniques suc...

Sintering of powders is a common means of producing bulk materials when melt casting is impossible or does not achieve a desired microstructure, and has long been pursued for nanocrystalline materials in particular. Acceleration of sintering is desirable to lower processing temperatures and times, and thus to limit undesirable microstructure evolution. Here we show that markedly enhanced sinter...

This work presents the mathematic models of the basic processes from an iron ore processing plant. Based on the mathematic models, using the Matlab/Simulink platform, it was achieved the simulation of the dosing process and simulation of the sintering process. The achieved mathematic model allows the determination of the material flows in the charge at their chemical composition variation, or a...