This paper is the first of a three part report on the transient thermal analysis of screw compressors. Knowledge of rotor-to-housing and rotor-to-rotor clearances is a fundamental first step in defining part dimensions that lead to a design with high efficiency and reliability, characteristics which must be balanced as they impose opposite demands on internal clearances. As reliability and perf...

This paper presents a new framework for recovering superquadrics with global deformations from multi-view real range data. The framework aims at improving confidence and accuracy of recovered models by utilizing multiview information, and consists of the initial superquadric model recovery, view registration, view integration, and final model recovery from integrated data. A quadrant analysis t...

This paper presents the modeling of a four rotor vertical take-off and landing (VTOL) unmanned air vehicle known as the quad rotor aircraft. The paper presents a new model design method for the flight control of an autonomous quad rotor. The paper describes the controller architecture for the quad rotor as well. The dynamic model of the quad-rotor, which is an under actuated aircraft with fixed...

single-phase squirrel cage and three-phase induction electromotors are the most popular electromotors used in industry from long ago. when an induction motor starts with direct connection method, it takes a lot of current from the power supply (several times the nominal current); so, several methods have been devised to start such electromotors. these methods either reduce the voltage of the st...

Unbalance, fatigue crack and rotor-stator rub are the three common and important faults in a rotor-bearing system. They are originally interconnected each other, and their vibration behaviors do often show strong nonlinear and transient characteristic, especially when more than one of them coexist in the system. This article is aimed to study the vibration response of the rotor system in presen...

In order to identify physical model parameters of a high-rise building, a new story stiffness identification method is presented based on a shear-bending model and the identification function. Although a shear building model may be the simplest conventional model for representing tall buildings, the system identification (SI) method using that model is not necessarily appropriate. This is becau...

A 2005 TRC report presents imbalance response measurements of a hollow test rotor supported on bump-type gas foil bearings. The top speed of the tests is 25 krpm, the limit of the drive router motor. The 2005 measurements show the gas foil bearings are prone to subsynchronous whirl with amplitudes of motion exacerbated by the imbalance condition of the rotor, i.e. a forced nonlinearity. Present...

Oil-free microturbomachinery (MTM) are inevitably subjected to base or foundation excitations: passenger and commercial transportation vehicles experiencing intermittent excitation from road conditions, and (multiple) periodic load excitations from internal combustion (IC) engines in turbochargers, for example. Too large base excitations can produce severe damage, even failure, due to hard coll...

The latest development in screw compressor (helical lobed compressor) rotor profile design and rotor manufacturing machinery have prioritized basic rotor profile surface, lead and divide. However, one error that at frrst looks very basic but at the same time almost impossible to eliminate, is dealt with in this paper. The error is rotor runout.