This paper presents the results of a numerical study on the heat transfer performance and the removal process of fluid particles under the influence of magnetohydrodynamic mixed convection in a horizontal channel with an open cavity. The bottom wall of the cavity is heated at a constant temperature (Th) while the top wall of the channel is maintained at a relatively low temperature (Tc). Air wi...

The thermo-hydraulic behavior of the air flow over a two dimensional ribbed channel wasnumerically investigated in various rib-width ratio configurations (B/H=0.5-1.75) atdifferent Reynolds numbers, ranging from 6000 to 18000. The capability of differentturbulence models, including standard k-ε, RNG k-ε, standard k-ω, and SST k-ω, inpredicting the heat transfer rate was compared with the experi...

The airflow in the modeled glottal constriction was simulated by the solutions of the Navier-Stokes equations for laminar flow, and the corresponding Reynolds equations for turbulent flow in generalized, nonorthogonal coordinates using a numerical method. A two-dimensional model of laryngeal flow is considered and aerodynamic properties are calculated for both laminar and turbulent steady flows...

In recent years, impinging streams have received increasing interest for their high efficiency in heat and mass transfer. This numerical study was conducted to investigate flow and heat transfer characteristics of one-way opposing jets of non-Newtonian fluids. Effects of Reynolds number impinging angle, momentum ratio and flow behavior index on mixing index were evaluated. The results showed im...

The validity of the compressible Reynolds equation to predict the local pressure in a gas-lubricated, textured parallel slider bearing is investigated. The local bearing pressure is numerically simulated using the Reynolds equation and the Navier-Stokes equations for different texture geometries and operating conditions. The respective results are compared and the simplifying assumptions inhere...

The scalar rms fluctuations in a turbulent jet were investigated experimentally, using highresolution, laser-induced fluorescence techniques. The experiments were conducted in a high Schmidt nuinber fluid (water), on the jet centerline, over a jet Reynolds number range of 3000<Re<24 000. It was found that the normalized scalar rms fluctuations c’/ C decrease with increasing flow Reynolds number...

It has hitherto been widely considered that a mixing layer is unstable at all Reynolds numbers. However this is untenable from energy considerations, which demand that there must exist a non-zero Reynolds number below which disturbances cannot extract energy from the mean flow. It is shown here that a linear stability analysis of similarity solutions of the plane mixing layer, including the eff...

We use DNS to study the effect of Prandtl number on mixing in weakly density stratified Kelvin-Helmholtz (KH) billows at low to moderate Reynolds numbers. The time evolution of the density field of the flow and the mixing are significantly influenced by the Prandtl number. By increasing the Prandtl number, the final amount of mixing increases for Reynolds that are too low to sustain three-dimen...

Hydraulic conditions required to initiate movement of unanchored residue materials are identified in the present study. Selected amounts of corn, cotton, pine needles, sorghum, soybean, sunflower, and wheat residue are placed in a flume on a sand surface, and flow is then introduced at the top of the flume in progressive increments. The discharge rate and flow velocity necessary to cause residu...

Steady and unsteady experimental data are presented for several xed geometry conditions from a test in the NASA Langley 0.3-Meter Transonic Cryogenic Tunnel. The purpose of this test was to obtain unsteady data for transonic conditions on a xed and pitching supercritical airfoil at high Reynolds numbers. Data and brief analyses for several of the xed geometry test conditions will be presented h...