A new application of the three-phase buck-resonant converter is presented in this paper. It is shown that the analyzed converter is suitable to operate as the rectifier stage in low power wind energy conversion systems (WECS) based on permanent magnet synchronous generators (PMSG) with variable wind speed. As main features, it presents a single controlled switch, simple implementation and contr...

We present experimental data on the coherent control of frequency conversion toward the vacuum-ultraviolet regime in xenon atoms, applying intense ultrashort picoseconds (ps) radiation pulses. We report on quantum interference between two resonantly enhanced frequency conversion processes (i.e., fifth harmonic generation and four-wave mixing). The conversion processes are driven by a fundamenta...

Nowadays with increasing use of numerous nonlinear loads, voltage and current harmonics in power systems are one of the most important problems power engineers encounter. Many of these nonlinear loads, because of their dynamic natures, inject time-varying harmonics into power system. Common techniques applied for harmonics measurement and assessment such as FFT have significant errors in presen...

This paper proposes a three-phase four-wire currentcontrolled Voltage Source Inverter (CC-VSI) for both power quality improvement and PV energy extraction. For power quality improvement, the CC-VSI works as a grid current-controlling shunt active power filter to compensate for harmonic and reactive power of loads. Then, the PV array is coupled to the DC bus of the CC-VSI and supplies active pow...

This chapter presents the theoretical basics of the electric power generation using doublyfed induction drives in wind turbines. This type of drive is the most utilized in wind power plants nowadays. This is mainly due to its fast dynamic response and reduced power electronics on the rotor side. This latter aspect is responsible for less harmonic pollution in the network and reduced acquisition...

The design and measured results of a compact, low cost, low conversion loss microstrip single balanced Schottky diodes mixer is proposed. This mixer is designed for Ka-band satellite transponder simulator to convert the 30 GHz radio-frequency (RF) signal down to the 20GHz intermediate-frequency (IF) signal with 9.8 GHz local oscillator (LO) frequency. This design takes full advantage of the fre...

This method is used to improve the efficiency of motor drive by power factor correction. It plays an important role in energy saving during energy conversion. A cuk dc -dc converter topology reduced the power quality problems and improve the power factor at input ac mains. A three-phase voltage-source inverter is used as an electronic commutator operates the PMBLDCM drive The concept of voltage...