Cables not only transfer the power needed to run electrical equipment, but also the data signals needed to operate them. To prevent errors and device failures, the same attention must be paid to the choice and installation of the cabling as is paid to the rest of the system. Dealing with data means considering signal integrity (SI). Since data signals are modulated electrical pulses, anything t...

The nature of the transmission medium (the electrical cable) and possible power/interference constraints coming from coexistence issues, forces Power Line Communication (PLC) signals to respect some emission limits [1, Chap.5]. Within this framework, pulse shaping may offer effective solutions to maximize Signal-to-Interference-Noise Ratio (SINR), while abiding by spectral constraints. The mode...

During the operation of BEPC, the cable isolation layer near the high voltage connector of the DC separator is often melted, which is probably caused by the HOMs power. This paper presents the measurement results of the HOMs shunt impedance, the calculation of the power dissipated in the separator and through the connector, and the analysis of the HOMs effects.

Concerns regarding possible transverse instabilities in RHIC and the SNS pointed to the need for measurements of the transverse coupling impedance of ring components. The impedance of the RHIC injection and abort kicker was measured using the conventional method based on the S21 forward transmission coefficient. A commercial 450 Ω twin-wire Lecher line were used and the data was interpreted via...

Recently, dry power transformer (Dryformer) that performs one step transformation from transmission to distribution voltage levels, has been introduced [1]. The Dryformer (dry power transformer) combines the features of power transformer with that of station distribution transformer, by utilising XLPE insulated round conductor cable for winding construction. The parameters of the cable winding ...

A system of multi-axis networked smart motors is developed to reduce complex cable harnesses. Motor control signals are sent over the DC power bus line and received by motors with integrated power amplifiers and controllers. Unlike traditional AC power line communication, the noise level and signal attenuation are much lower for the DC power bus communication. This allows for high fidelity, bro...

Cable termination faults are problematic in electrical networks almost always. Technology has solved problems somewhat, but there are many annual reports about damaged cable terminations. For analyzing the problems, faults in two regional electricity companies are studied. At first step, damaged cable terminations are analyzed statistically and grouped according to their problems. Then, some of...

In this paper the influence of the metallic sheath in the magnetic field generated by underground single core power cables is studied. When dealing with underground power cables, sheath circulating currents can be induced. These currents produce power losses in the sheaths and decrease the ampacity (capacity of carrying current) of the cables. The circulating sheath currents generate a magnetic...

In this study, nonlinear vibration of a composite cable is investigated by considering nonlinear stress-strain relations. The composite cable is composed of an aluminum wire as reinforcement and a rubber coating as matrix. The nonlinear governing equations of motion are derived about to an initial curve and based on the fundamentals of continuum mechanics and the nonlinear Green-Lagrangian stra...

Underground cable power transmission and distribution system are susceptible to faults. Accurate fault location for transmission lines is of vital importance. A quick detection and analysis of faults is necessity of power retailers and distributors. This paper reviews various fault locating methods and highly computational methods proposed by research community that are currently in use. The pa...