in this paper a mesh-free model of the functionally graded material (fgm) plate is presented.  the piezoelectric material as a sensor and actuator has been distributed on the top and bottom of the plate, respectively. the formulation of the problem is based on the classical laminated plate theory (clpt) and the principle of virtual displacements. moreover, the particle swarm optimization (pso) ...

We propose a new mass sensor based on thickness-twist edge modes in a piezoelectric plate of 6mm crystals. By performing a theoretical analysis, a simple expression of sensitivity is obtained. The proposed sensor has an important advantage in the sense that it can be mounted away from the edge of the plate where the motion is insignificant and, thus, the operation of the device is unaffected. C...

In this paper, a three dimensional analysis of arbitrary straight-sided quadrilateral nanocomposite plates are investigated. The governing equations are based on three-dimensional elasticity theory which can be used for both thin and thick nanocomposite plates. Although the equations can support all the arbitrary straight-sided quadrilateral plates but as a special case, the numerical results f...

the nonlocal nonlinear buckling of a double layer graphene sheet (dlgs) covered by zinc oxide (zno) piezoelectric layers is investigated in this study. the surrounding circumstances of the system are considered as a pasternak foundation including spring constants and a shear layer. graphene sheets are subjected to longitudinal magnetic field and biaxial forces. on the other hand, the zno piezoe...

Exact solutions are derived for three-dimensional, anisotropic, linearly magneto-electroelastic, simply-supported, and multilayered rectangular plates under static loadings. While the homogeneous solutions are obtained in terms of a new and simple formalism that resemble the Stroh formalism, solutions for multilayered plates are expressed in terms of the propagator matrix. The present solutions...

We study the asymptotic behavior of a three dimensional flat, heterogeneous and anisotropic piezoelectric body when its thickness seen as a parameter goes to zero. Depending on the type of the electrical loading two models are obtained which are related to the plate used as a sensor or as an actuator. These models are explicitly derived in any piezoelectric crystal symmetry class. For some of t...

Lead zirconate titanate (PZT) ceramics is usually used as a piezoelectric material. However it has characteristics of not only piezoelectricity but also flexoelectricity. Piezoelectricity is a phenomenon that electric polarization is induced by strain, and flexoelectricity is the one that the polarization is induced by strain gradient. In this study, flexoelectricity in poled soft PZT ceramics ...

Periodic arrays of shunted, piezoelectric patches are employed to control waves propagating over the surface of plate structures, and corresponding vibrations. The shunted, piezoelectric patches act as sources of impedance mismatch, which gives rise to interference phenomena resulting from the interaction between incident, reflected and transmitted waves. Periodically distributed mismatch zones...

The purpose of this study was to use computational fluid dynamics software Fluent, the numerical simulation to discuss the impact pressure within the flow channel device for flat radiator fan heat flow characteristics. Piezoelectric fan was placed in front of the flow channel, and the cold air flow was introduced to the radiator cooling fan, and thus generated vortex fluid in the flow path arou...

Current inductors are the major impediment for miniaturization of electronics, due to the lack of magnetic materials with suitable high frequency properties. Future economically viable miniaturized high frequency electronic components require a low loss high frequency magnetic nanocomposite paste that is compatible with the low temperature powered circuit board (“PCB”) process. Inframat Corpora...