A thermomechanical study of the effects of mold topography on the solidification of Aluminum alloys at early times is provided. The various coupling mechanisms between the solid-shell and mold deformation and heat transfer at the mold/solid-shell interface during the early stages of Aluminum solidification on molds with uneven topographies are investigated. The air-gap nucleation time, the stre...

Clostridium tyrobutyricum is considered the main agent of late-blowing defect in the production of hard cheese. Here, we described the draft genome sequences and annotation of C. tyrobutyricum strain UC7086, which was isolated from Grana Padano cheese with blowing defect, and C. tyrobutyricum DSM 2637 type strain in a comparative study.

Here we present an alternative, new, unconventional lithographic technique developed to create dense and multilevel nanostructure pattern transfer using a highly accurate polyurethane acrylate (PU, MINS101m, Minuta Tech.) mold and a polyelectrolyte multilayer as the adhesion promotion layer. Specifically, we demonstrate the pattern transfer of periodic 80 nm lines with 400 nm height and complex...

Abstract Investigation of capability high potential pineapple ( Ananas comosus ) leaves powder (PLP) as reinforcing material on the starch-based foam production has not been reported. This study was aimed to characterize physical and mechanical properties starch formed from mixture cassava PLP. The foams were made using a baking process thermo-pressing machine at temperature 170°C 180°C lower u...

The basis for some common gypsum wallboard mold remediation practices was examined. The bottom inch of several gypsum wallboard panels was immersed in bottled drinking water; some panels were coated and others were untreated. The panels were examined and tested for a period of 8 weeks. This study investigated: (a) whether mold growth, detectable visually or with tape lift samples, occurs within...

In this study, the effect of sintering temperature on physical, chemical and tribological effects sintered automotive friction materials was investigated. Using powder metallurgy method, 3 different samples were produced with codes A1, A6 A11. Mixing, pressing processes applied respectively as production steps. Mixing time is 90 minutes, speed 15 rpm. The pressure 250 MPa duration 1 min. 800 °C...

T he issue of mold contamination has drawn the national and international spotlight on the heels of publicity about prominent situations , such as a hotly contended link between mold and severe illness—and one death—in 10 Ohio infants in 1993 and 1994; a major 2001 insurance battle over the moldy Dripping Springs, Texas, house of Melinda Ballard and her family; the mushrooming mold infestations...

In-mold assembly process has been used for manufacturing articulated structures at the macro scale. But the in-mold assembly process at the mesoscale behaves differently and poses new challenges due to reduced structural rigidity of the mesoscale premolded component. One of the major challenges that need to be addressed is that of the plastic deformation of the premolded component during the se...

Mold is ubiquitous, and exposure to mold and its products of metabolism is unavoidable, whether indoors or outdoors. Mold can produce a variety of adverse health outcomes by four scientifically validated pathophysiologic mechanisms: hypersensitivity, toxicity, infection, and irritation. Some adverse health outcomes have been attributed to mold for which mechanisms of injury are not well defined...

In this paper we propose a multicast-on-large-demand (MOLD) approach to the flash crowd problem. A MOLD Web server may dynamically open a multicast channel for resources when detecting a very high demand for them, and it reverts back to the normal unicast mode when the flash crowd subsides. A number of mechanisms necessary for realizing the MOLD system are thoroughly discussed. We have implemen...