Background and Purpose: Most projections of the global energy use predict that biomass will be an important component of primary energy sources in the coming decades. Short rotation plantations have the potential to become an important source of renewable energy in Europe because of the high biomass yields, a good combustion quality as solid fuel, ecological advantages and comparatively low bio...

this study was conducted in perennial alfalfa farm infected by weeds located at km 7 hamadan-tehran road in the spring of 2014 and 2015 in a randomized complete block design with 11 treatments and 4 replications compared with control to investigate the effects of different harvest times of first cutting on the increase or decrease in percentage of dry weight of weeds and also alfalfa in second ...

A degraded oak savanna in southwestern Wisconsin is being restored using intensive cutting of undesirable shrubsbuckthorn (Rhamnus cathartica), prickly ash (Zanthoxylum americanum), honeysuckle (Lonicera spp.)-and selective removal of trees that are crowding the open-grown bur (Quercus macrocar/Ja) and white (Q. alba) oaks. Land use records and historic aerial photographs have been used to guid...

An important source of microplastics (MPs) in the Baltic Sea waters is plastic waste, which fragmented natural environment. The pilot research on identification surface Port Gdynia presented. In this paper, particle sizes 0.3–5 mm harbour seawaters were investigated. Microplastics collected from five basins using an unmanned mobile unit, HydroDron-1. Sampling port water was conducted over four ...

Between 2006 and 2013, we salvaged and necropsied 362 seabird specimens from Tern Island, French Frigate Shoals, Northwestern Hawaiian Islands. Plastic ingestion occurred in 11 of the 16 species sampled (68.75%), representing four orders, seven families, and five foraging guilds: four plunge-divers, two albatrosses, two nocturnal-foraging petrels, two tuna-birds, and one frigatebird. Moreover, ...

Finite edge radius plays a significant role in finish machining processes when the undeformed chip thickness is often less than a few hundred microns and comparable to the size of the cutting edge. At suboptimal cutting speeds, edge radius tools may induce deeper subsurface plastic deformation, increase microhardness through work-hardening and mostly due to the ploughing of the cutting edge. On...

Optimization of cutting parameters is important to achieve high quality in the machining process, especially where more complex multiple performance optimizations are required. The present investigation focuses on the multiple performance optimizations of machining characteristics of unidirectional glass fiber reinforced plastic (UD-GFRP) composites. The cutting parameters used for the experime...

X-ray diffraction, optical microscopy and microhardness testing have been used to study properties which develop in micro-cut AISI 1045 steel. The influence of the ploughing effect on residual stresses, surface deformation and work hardening, and the tool quality were investigated. Tensile residual stresses, caused by the heat generated in the material during the cutting process, were observed ...