TWIP-cored three-layer steel sheets were newly fabricated by hot rolling of TWIP steel sheet surrounded by low-carbon (LC) or interstitial-free (IF) steel sheets. TWIP/LC or TWIP/IF interfaces were well bonded without pores or voids, while a few pearlites were thinly formed along the interfaces. The strengths and elongation of the TWIP-cored sheets increased as the volume fraction of TWIP-cored...

The redistribution of carbon after tempering of a novel nanocrystalline bainitic steel consisting of a mixture of supersaturated ferrite and retained austenite has been analyzed by atom probe tomography. No direct evidence supporting the additional carbon enrichment of austenite beyond that initially achieved during the bainite heat treatment was obtained during subsequent tempering of this hig...

Application of thermoplastic materials has increased dramatically in recent decades due to its recyclability, low density, resistance to chemical changes. The friction stir welding process is one of the new methods of solid state welding, which has recently undergone a significant improvement. In this research, using a new tool Made of plain carbon steel st37 in friction stir welding and low co...

The forming limit diagram (FLD) is probably the most common representation of sheet metal formability and can be defined as the locus of the principal planar strains where failure is most likely to occur. Low carbon steel sheets have many applications in industries, especially in automotive parts, therefore it is necessary to study the formability of these steel sheets. In this paper, FLDs, wer...

Materials that can perform simultaneous functions allow for reductions in the total system mass and volume. Developing technologies to produce flexible batteries with good performance in combination with high specific strength is strongly desired for weight- and power-sensitive applications such as unmanned or aerospace vehicles, high-performance ground vehicles, robotics, and smart textiles. S...

New developments with bainite have resulted in a steel with an ultimate tensile strength of 2500 MPa, a hardness of 600-670 HV and a toughness in excess of 30-40 MPa m [1]. The novel microstructure is generated in a high carbon (0.98 wt.%) high silicon (1.46 wt.%) steel austenitized for 15 min. at 1000 oC, and then isothermally transformed at temperatures of ∼200 oC. Iron does not diffuse durin...

The understanding of the hardenability is important in steel development with respect to weldability of steels as well as to the design of quenched and tempered steels. The common way to judge if steel is suitability to welding is the use of a carbon equivalent, which reflects the alloy content to the hardenability of the heat affected zone (HAZ). Most common of these equivalents is the IIW car...

Purpose: The aim of the paper is to design heat treatment conditions of dual-phase steel and to determine their influence on the structure and mechanical properties of steel. Design/methodology/approach: The heat treatment of the C-Mn steel in order to obtain a dual-phase ferritic – martensitic structure of desirable phase fractions was realized. To investigate the influence of heat treatment p...

Several deficient steel structural members require to be strengthened all over the world. In this article, horizontal defects were generated at three locations (top, middle, and bottom) on the middle element and the middle of the side element. Consequently, the effects of the location of such defects on axial behavior of Carbon Fiber Reinforced Polymer (CFRP) strengthened steel Square Hollow Se...

The evaporation of inertial confinement fusion first wall materials from unattenuated pellet X-rays and from radiation emitted by a cavit.y buffer qas is examined. The low vapor pressure and low X-ray attenuation coefficient of carbon give it a lower erosion rate than stainless steel, despite the larger thermal conductivity of Type 316 stainless steel. For the argon buffer gas containing 0.2% N...