Diamond-like carbon (DLC) and silicon carbide (SiC) coatings are attractive because of low friction coefficient, high hardness, chemical inertness and smooth finish, which they provide to biomedical devices. Silicon wafers (Si(waf)) and silicone rubber (Si(rub)) plates were coated using plasma-enhanced chemical vapour deposition (PE-CVD) techniques. This article describes: 1- the characterizati...

For decades Electrochemical Polishing (ECP) has been used for surface polishing of bulk metal materials such as copper and stainless steel. However, it was found very challenging to planarize patterned copper films electrodeposited on silicon wafers. This work studied the mechanisms of ECP, the surface profiles and ECP effects of copper bulk and films in various electrolyte solutions. Satisfied...

The influence of diamond like carbon films properties on quantum efficiency of prepared transmission photocathodes has been investigated. DLC films were deposited on silicon substrate and stainless steel mesh by PECVD using methane, argon and hydrogen or deuterium gas mixtures. Photocathodes prepared with deuterated DLC film have higher quantum efficiency than photocathodes prepared with hydrog...

the dynamic behavior of three high manganese steels with very different stacking faultenergy (sfe) values (4-30 mj/m2) were studied using high strain rate torsional tests. the hotrolledmicrostructure of the steel with the lowest sfe of 4 mj/m2 consisted of a duplex mixture ofaustenite and ε-martensite, but those of the other two steels were fully austenitic. the deformedmicrostructures were stu...

This paper describes an improved microwave digestion procedure for steel samples of various kinds intended inductively coupled plasma atomic emission spectrometry, including low alloy steel, stainless alloyed tool and high-speed steel. Their resulting solutions were used the simultaneous quantification elements together with several light boron, aluminum, silicon, phosphorous. Conventional meth...

High accuracy dental impression is usually a first step during fabrication of indirect restorations that have to be seated in or on prepared teeth. The dimensional stability of the impression material could have an influence on the accuracy of the final restoration. Elastomeric materials (additioncured silicones and condensationcured silicones) are most frequently used as the impression materia...

Calorimeters with a high granularity are a fundamental requirement of the Particle Flow paradigm. This paper focuses on the prototype of a hadron calorimeter with analog readout, consisting of thirty-eight scintillator layers alternating with steel absorber planes. The scintillator plates are finely segmented into tiles individually read out via Silicon Photomultipliers. The presented results a...

Calorimeters with a high granularity are a fundamental requirement of the Particle Flow paradigm. This paper focuses on the prototype of a hadron calorimeter with analog readout, consisting of thirty-eight scintillator layers alternating with steel absorber planes. The scintillator plates are finely segmented into tiles individually read out via Silicon Photomultipliers. The presented results a...

Bainite has been obtained by heat treatment at temperatures as low as 125°C in a high carbon, high silicon steel. This has had the effect of greatly re® ning the microstructure, which is found to have a strength in excess of 2.5 GPa together with an ability to ̄ ow plastically before fracture. Such properties have never before been achieved with bainite. In this paper metallographic details are ...

Local electron work function, adhesive force, modulus and deformation of ferrite and austenite phases in a duplex stainless steel were analyzed by scanning force microscopy. It is demonstrated that the austenite has a higher electron work function than the ferrite, corresponding to higher modulus, smaller deformation and larger adhesive force. Relevant first-principles calculations were conduct...