We describe a fully differential amplifier for oversampled A/D converter applications. This amplifier employs a single stage telescopic architecture using both N-type and P-type gain-boosting technique with capacitive feedback. This architecture offers extremely high gain, low noise, low power and the need for compensation. But the potential slow-settling problem due to the slow doublet should ...

A large number of health and wellness applications wish to monitor electrocardiogram signal (ECG) in the least intrusive way possible. The use dry textile electrodes with high input impedance bio-amplifiers is a common technique. This paper presents novel ultra-high buffer obtain reduced capacitance enhance acquisition results for or non-contact capacitive ECG electrodes. Based on different boo...

This paper presents an improved linearity variable-gain amplifier (VGA) in 0.18-µm CMOS technology. The lineari­ty improvement is resulted from employing a new combinational technique, which utilizes third-order-intermodulation (IM3) cancellation mechanism using second-order-intermodul­ation (­IM2) injection, and intermodulation distortion (IMD) sinking techniques. The proposed VGA gain cell co...

 Abstract—The dual-band recording of the local-field potential (LFP, 0.1Hz~200Hz) and the spike potential (SP, 200Hz~10kHz) is important for physiological studies at the cellular level. Recent study shows that the LFP signal plays important roles in modulating many profound cellular mechanisms. Although various bio-signal acquisition circuits have been reported over the years, few designs are ...

An optical receiver for 40 Gbit=s communication systems with 8274 V=W conversion gain and 950 mVp–p limiting differential output is reported. A back-to-back sensitivity of 9.4 dBm at a bit error rate of 10 12 was observed for a 2 1 pseudorandom binary sequence. The receiver incorporates an InP based pin diode, a transimpedance amplifier and a limiting amplifier. This is the largest conversion g...

a high accurate and low-voltage analog cmos current divider which operates with a single power supply voltage is designed in 0.18µm cmos standard technology. the proposed divider uses a differential amplifier and transistor in triode region in order to perform the division. the proposed divider is modeled with neural network while tlbo algorithm is used to optimize it. the proposed optimization...

–This paper presents a highly linear Operational Transconductance Amplifier (OTA) that combines two linearization techniques, one with adaptive biasing of differential pairs and second with resistive source degeneration. The Operational Transconductance Amplifier has ±0.9v power supply. Operational Transconductance Amplifier has been simulated with TANNER 0.18μm CMOS technology in Tspice. The s...

A fully differential self-biased inverter-based folded cascode amplifier which uses the feedforward-regulated cascode principle is presented. A detailed small-signal analysis covering both the differential-mode and the common-mode paths of the amplifier is provided. Based on these theoretical results a design is given and transistor level simulations validate the theoretical study and also demo...

A low-power, high-gain CMOS low noise amplifier (LNA) for use as the first stage of a subsampling receiver is proposed. The performance of +96-dB voltage gain and less than 1-dB Noise Figure (NF) with very low power consumption is reported for the first time and makes it suitable for subsampling mixer with Track and Hold (T/H) circuit. The LNA contains both tuned and inductorless amplifier stag...