BACKGROUND Negative-pressure wound therapy is traditionally achieved by attaching an electrically powered pump to a sealed wound bed and applying subatmospheric pressure by means of gauze or foam. The Smart Negative Pressure (SNaP) System (Spiracur, Inc., Sunnyvale, Calif.) is a novel ultraportable negative-pressure wound therapy system that does not require an electrically powered pump. METH...

Vertical turbine pumps are designed to operate with the pump shafts in tension (downthrust). Most pump and motor manufacturers caution users to not operate the vertical turbine pumps at conditions that result in “upthrust.” Upthrust conditions are usually encountered for a few seconds each time the pump is started; however, the pump should not be operated for periods longer than a few seconds i...

The effect of the discharge pressure on the performance of the trans-critical CO2 heat pump with a low gas-cooler outlet temperature is experimentally investigated on a test rig of water source heat-pump water heater. The optimal discharge pressure of the trans-critical CO2 heat pump is investigated under different external operation conditions. When the tap-water temperature is low, the charac...

The goal of this research is the derivation of method for evaluation of efficiency improvement potential for district heating systems with focus on variable speed centrifugal pump. The effectiveness of the usage of the proportional pressure control is compared with the constant pressure control. This is why, energy calculation analyses have been realized for variable speed centrifugal pumps, an...

This study aims to build a dynamic model of direct steam generation (DSG) solar power system coupled with accumulator meet electricity demands for hospital under transient environmental conditions in Libya. The main components the are DSG parabolic trough collectors, accumulator, turbine, condenser and circulation pump. is modelled via using Simulink\Simscape software blocks integrated MATLAB f...

A high-pressure electro-osmotic (EO) micro-pump fabricated by a sol–gel process is shown to be potentially effective as a fluid-driving unit on chip-scale analytical systems. A silica monolithic matrix with a morphology of micron-scaled through pores was synthesized within the 100 m inner diameter (i.d.) fused-silica capillary of the micro-pump. The monolith bonds directly with the capillary wa...

We developed and tested a high-pressure optical chamber system for cultivation and microscopic observation of deep-sea organisms. The system is composed of an optical chamber, a highpressure pump, a pressure sensor and a microscope. The chamber has an observation cavity, 2 cultivation cavities and 2 sapphire windows. The pump is employed for perfusion of culture medium and for increasing the pr...

The paper is devoted to the analysis of operating cycle a high-pressure injection pump used in common rail systems. investigation based on experimental activities, and it carried out novel set-up that allows measurements instantaneous pressure piston working chamber. A single plunger has been equipped with piezo-resistive transducer which for measurement signal during operation test rig. descri...

the goal of this research is the derivation of method for evaluation of efficiency improvement potential for district heating systems with focus on variable speed centrifugal pump. the effectiveness of the usage of the proportional pressure control is compared with the constant pressure control. this is why, energy calculation analyses have been realized for variable speed centrifugal pumps, an...