This article reports the effects of various artificial aging methods and lubrication modes (dry, mist, wet) on the recorded cutting forces and chip morphology in drilling Al-Si-Mg (A356) cast alloys. In the course of this work, the work part sampled were as-received alloy (T0), solution heat-treated alloy (SHT) and then aged alloys at 155°C, 180°C, and 220°C (T4, T6, T61, T7), respectively. The...

Utilization of metalworking fluids in the technological process of metalworking brings its advantages and disadvantages, mainly associated with the contamination of the working air through cutting fluid mist. The primary aim of this article is to approximate the mechanism of aerosols generation which contaminates the working air and to draw the attention to the problem of quantification of gene...

Two types of alumina-based cutting tools with compositions of 90 vol.% Al2O3+10 vol.% ZrO2 and 80 vol.% A12O3+20 vol.% TiC are produced by isostatic pressing and sintering technique. The effects of these additives on the mechanical properties and cutting performance of these materials are investigated. The tool life in both materials is examined under identical conditions on cutting a grey cast...

Chore division, introduced by Gardner in 1970s [10], is the problem of fairly dividing a chore among n different agents. In particular, in an envy-free chore division, we would like to divide a negatively valued heterogeneous object among a number of agents who have different valuations for different parts of the object, such that no agent envies another agent. It is the dual variant of the cel...

objective: in order to study the effect of different concentrations of iba hormone on rooting of olive cuttings in spring and winter of 2012-2013 in a greenhouse in jiroft, iran. methods: a split-plot experiment was conducted on the basis of a randomized complete block design in which hardwood cuttings of one-year-old olive plants cv. manzanilla with the diameter of 0.7-1 cm were used. the main...

on account of some complexities such as fluid-structure interaction and extra-large deformation problems, complete simulation of abrasive water jet cutting process is very hard. the main goal of this paper is to overcome these difficulties through comprehensive simulation in ls-dyna commercial software. for this purpose the smoothed particle hydrodynamics (sph) and arbitrary lagrangian eulerian...

surface roughness is one of the most important parameters that plays very critical role in determining the quality of engineering components. a good surface quality resulting in improve of fatigue strength, corrosion and wear resistance of the workpiece. on the other hand, increasing cutting speed and decreasing time of machining are desirable for manufacturers in order to reduce costs and incr...

experiments were conducted at the horticulture research farm of horticulture department, bangabandhu sheikh mujibur rahman agricultural university (bsmrau), salna, gazipur during december, 2007 to may, 2009 to investigate the effect of bulb cutting and potting media on propagation of hippeastrum. the bulb cutting significantly influenced all the parameters except days required to first leaf eme...

due to the importance of weed control and the limitations of mechanical methods in some places, in this research the water jet cutting for weed control was investigated. the cutting tests were performed on camel thorn weed in shahid bahonar university of kerman. the water jet pressure of 90 bars was achieved with the aid of a suitable pump. the cutting time was studied in a completely randomize...

The effects of cutting tool coating material and cutting speed on cutting forces and surface roughness were investigated by Taguchi experimental design. Main cutting force, Fz is considered as a criterion. The effects of machining parameters were investigated using Taguchi L18 orthogonal array. Optimal cutting conditions were determined using the signal-to-noise (S/N) ratio which is calculated ...