Mixed-surface octyl/methoxyundecyl a-zirconium phosphonates (ZrPs) were investigated as distributed nanoscale fillers, in concentrations up to 50% w/w, for the purpose of increasing the elastic modulus and yield strength of polycaprolactone (PCL) without a meaningful reduction of its ductility. The volumetric nanoparticle loadings were estimated to be over 70% higher than those in nanocomposite...

Many natural structures use a foam core and solid outer shell to achieve high strength and stiffness with relatively small amounts of mass. Biological foams, however, must also resist crack growth. The process of crack propagation within the struts of a foam is not well understood and is complicated by the foam microstructure. We demonstrate that in cancellous bone, the foam-like component of w...

The lack of durability in concrete repairs induces repair failures in field and endless “repair of repairs”. Most often drying shrinkage of “new” repair material restrained by “old” concrete substrate causes cracking in the repair material, combined with interface delamination between the repair and the concrete substrate, which may also introduce chlorides, oxygen, moisture, alkali or sulphate...

In this paper, the effective parameters on the ductility demand of the seismically base isolated structure are investigated, and then a relation between the strength reduction factor and the target ductility is presented. The investigation has been conducted by modelling the base isolated structure as a two degree of freedom model in the OpenSees software, and the possibility of yielding in the...

Al-Si-based casting alloys have a great potential in various industrial applications. Common strengthening strategies on these alloys are accompanied inevitably by sacrifice of ductility, known as strength-ductility trade-off dilemma. Here, we report a simple route by combining rapid solidification (RS) with a post-solidification heat treatment (PHT), i.e. a RS + PHT route, to break through thi...

Recently, steel fibre reinforced polymers (SFRP) sheets have been introduced for the repair and rehabilitation of concrete structures. Few researchers studied the behaviour of the concrete columns wrapped with SFRP sheets; however, several critical parameters such as the cost and ductility effectiveness of the SFRP wrapped concrete columns have been lightly addressed. Thus, the main objective o...

Current concrete technology has made higher concrete grades more affordable to mid and high-rise buildings; hence its use has been increasing in the late years as it allows for smaller cross-sections, reduction of the structure’s weight, improve durability, among other benefits. However, it is known that brittleness of plain concrete increases with the strength; therefore, some national codes h...

Microstructure evolutions and mechanical properties of a commercially pure titanium (CP-Ti, grade 2) during multi-pass rotary-die equal-channel angular pressing (RD-ECAP) and cold rolling (CR) were systematically investigated in this work, to achieve comprehensive property for faster industrial applications. The obtained results showed that the grain size of CP-Ti decreased from 80 μm of as-rec...

In order to calculate the flexural strength of normal-strength concrete (NSC) beams, the nonlinear actual concrete stress distribution within the compression zone is normally replaced by an equivalent rectangular stress block, with two coefficients of α and β to regulate the intensity and depth of the equivalent stress respectively. For NSC beams design, α and β are usually assumed constant as ...

It follows from the Chapter 7 that, except for very short gauge lengths, percent elongation is mainly influenced by uniform elongation, and is thus dependent upon the strain-hardening capacity of the matrix. In contrast, reduction in area is more a measure of the deformation required to produce fracture, and its chief contribution arises from the necking process. The work of Groom (1971) illust...