Peat normally has high organic matter content and is generally associated with high compressibility and high magnitude and rates of creep. It may also be associated with poor strength characteristics and a risk of large deformation. The main specifications in the peat nature are the presence of acidic or less commonly alkaline media, combined with a high level of ground water. One of the most c...

In this paper we will investigate torus actions on complete manifolds with calibrations. For Calabi-Yau manifolds M with a Hamiltonian structure-preserving k-torus action we show that any symplectic reduction has a natural holomorphic volume form. Moreover Special Lagrangian (SLag) submanifolds of the reduction lift to SLag submanifolds of M , invariant under the torus action. If k = n− 1 and H...

In recent years, there have been many attempts to reuse molten slag. Molten slag is obtained through further treatment of incinerated ash produced in the disposal process of garbage or sewage sludge and is used in building materials, such as brick. To establish the safety of such slag, its physical properties and metal contents were investigated in this study. After examining the physical and c...

In the conventional continuous casting of steel, either mold powder or oil can be added to lubricate the mold from sticking to the solidifying steel shell. The mold powder melts to form a molten slag or flux layer, and also acts to protect the molten steel from oxidation, to insulate the molten steel from heat loss, to absorb inclusions from the molten steel, to regulate heat transfer to mold w...

It is essential to lubricate the shell since inadequate lubrication leads to defects in the steel product (e.g. longitudinal cracks, sticker breakouts and star cracks). The liquid layer of the slag film, formed between the shell and the mould, lubricates the newly formed shell; the lubrication increases with increasing liquid slag thickness (dl). Lubrication is usually represented by the powder...

Vanadium is an important metal used almost exclusively in ferrous and non-ferrous alloys due to its physicochemical and mechanical properties such as grain refinement, high tensile strength, hardness and fatigue resistance; it has a wide range of uses in the metallurgical and chemical sectors [1–3]. There are mainly three kinds of raw materials, bone coal, vanadium slag and waste vanadium catal...

Many phenomena in continuous casting including the formation of surface defects are greatly affected by heat transfer in the mold. The interfacial slag layers between the solidifying steel shell and the mold wall dominates the resistance to heat removal and thus controls mold heat transfer. Surface defects, such as longitudinal cracks and star cracks have been associated with variation of slag ...

An experimental study was performed to measure the rate of reduction of iron oxide from calcia-silica-alumina slag by carbon in iron, and to determine whether the reaction rate can be increased by electrochemical means. It is shown that the reaction rate depends on both the ferric-ferrous cation ratio, and on the total amount of iron in the slag. It was observed that ferric cations are reduced ...