Flanged shear walls are used extensively in moderate- and high-rise buildings to resist lateral loads induced by earthquakes. The seismic performance of many buildings is, therefore, closely linked to the behavior of the reinforced concrete walls. They must be carefully designed to provide not only adequate strength, but also sufficient ductility to avoid brittle failure under strong lateral lo...

A series of analytical and experimental investigations is presented to study the response and failure of pyramidal truss core sandwich panels made of carbon fiber composite under axial compression. In the analytical part of the study, three failure modes: (i) Euler or core shear macro-buckling, (ii) face wrinkling, and (iii) face sheet crushing, were considered and theoretical relationships for...

Original scientific paper Research of bamboo-wood composites compression performance provides a basis for material selections for prestressed glued bamboo-wood beams and other components whose compression is mainly shared by glued bamboo-wooden composites. Four kinds of wood and two kinds of bamboo were selected to comprise 22 groups (6 specimens each group) divided into 4 batches to study the ...

BACKGROUND Options for management of acute right ventricular (RV) failure are limited. This report describes preliminary testing of a temporary RV assist device that acts by direct compression of the RV. The system comprises a pancake-shaped silicone balloon (5 cm diameter) connected to a drive console that delivers a 65-mL pneumatic pulse during cardiac systole. METHODS AND RESULTS Initial i...

The eccentric compression behavior of laminated bamboo lumber (LBL) columns with a chamfered section was investigated using eccentricity 30 mm, 60 90 mm and 120 mm. effect ratio on the ultimate bearing capacity, strain failure mode analyzed through tests. modes LBL different eccentricities were basically same, which belonged to brittle tension failure. With increase in ratio, capacity gradually...

Little is known about the mechanical forces acting on extracorporeal circuit tubing with prolonged roller pump use during extracorporeal membrane oxygenation (ECMO). We examined the time to tubing rupture of three different materials during actual roller pump use, mean and standard deviation (SD) (SD shown in parentheses): Tygon (control) 243.7 h (175.4); LVA 121 h (14.3); and SRT 6.6 h (2.1). ...

There is increasing evidence that, in addition to bone mass, bone microarchitecture and its mechanical load distribution are important factors for the determination of bone strength. Recently, it has been shown that new high-resolution imaging techniques in combination with new modeling algorithms based on the finite element (FE) method can account for these additional factors. Such models thus...

The behavior of impact damaged composite laminates under cyclic load is crucial to achieve a damage tolerant design structures. A sufficient residual strength has be ensured throughout the entire structural service life. In this study, set 27 impacted coupon specimens subjected quasi-static and compression load. After long intervals without detectable growth, fail through sudden lateral propaga...

An evaluation of the failures of coal under variable conditions in relation to the stability of coal pillars is an important issue for coal mining. This paper presents the results of an experimental investigation of the mechanical behavior of brittle coal under plane-strain biaxial stress state (PSBSS) compression. The synthetic specimens were meant to test the ductile properties. Modified surf...

simultaneous fractures of the femoral neck and shaft are not common injuries, though they cannot be considered rare. herein, we report our experience with a patient with bilateral occurance of this injury. up to the best of our knowkedge this is the first case reported in literature in which correct diagnosis was made initially. both femurs were fixed using broad 4.5 mm dynamic compression plat...