single-phase squirrel cage and three-phase induction electromotors are the most popular electromotors used in industry from long ago. when an induction motor starts with direct connection method, it takes a lot of current from the power supply (several times the nominal current); so, several methods have been devised to start such electromotors. these methods either reduce the voltage of the st...

Unbalance, fatigue crack and rotor-stator rub are the three common and important faults in a rotor-bearing system. They are originally interconnected each other, and their vibration behaviors do often show strong nonlinear and transient characteristic, especially when more than one of them coexist in the system. This article is aimed to study the vibration response of the rotor system in presen...

We have already reported an advanced method for producing a radially-anisotropic rare earth composite bonded magnet with continuously controlled direction of anisotropy. The magnet has been applied to an inner rotor as a practical usage. In this study, the outstanding preparation method was adopted into the preparation of a magnet applied for an outer rotor. An optimized condition of extrusion ...

This paper presents the development of a mixed-variable optimization framework for the aeroelastic analysis and design of active twist rotors. Proper tailoring of the blade properties can lead to the maximization of the active twist and the control authority for vibration reductionunder operating conditions. Thus, usingmathematical optimization, the cross-sectional layout is designed using cont...

A 2005 TRC report presents imbalance response measurements of a hollow test rotor supported on bump-type gas foil bearings. The top speed of the tests is 25 krpm, the limit of the drive router motor. The 2005 measurements show the gas foil bearings are prone to subsynchronous whirl with amplitudes of motion exacerbated by the imbalance condition of the rotor, i.e. a forced nonlinearity. Present...

Oil-free microturbomachinery (MTM) are inevitably subjected to base or foundation excitations: passenger and commercial transportation vehicles experiencing intermittent excitation from road conditions, and (multiple) periodic load excitations from internal combustion (IC) engines in turbochargers, for example. Too large base excitations can produce severe damage, even failure, due to hard coll...

The latest development in screw compressor (helical lobed compressor) rotor profile design and rotor manufacturing machinery have prioritized basic rotor profile surface, lead and divide. However, one error that at frrst looks very basic but at the same time almost impossible to eliminate, is dealt with in this paper. The error is rotor runout.

An aeroelastic model of a smart rotor system (which incorporates blade-mounted trailing-edge flap actuators and conventional root pitch actuation) is presented in linear time invariant state space form. The servo-flap deflections are modeled as producing incremental lift and moment variations, so that any linear aerodynamic actuator can be evaluated. This smart rotor model is used to conduct pa...

This paper present a new advanced control algorithm based on continuous minimization of predicted tracking errors, to achieve torque, rotor speed and rotor flux amplitude tracking objectives. This algorithm called a new Adaptive Nonlinear Predictive Control to induction motor drive uses a combination of the adaptive observer for rotor flux and Cascaded Nonlinear Predictive Control technique. Th...

This paper proposes an adaptive flux observer for induction motors, where stator and rotor resistances are estimated in online environments. The variation of motor parameters during operation degrades the performance of the controller and the flux observer. Among the parameters of induction motors, rotor resistance is a crucial one for flux estimation, and stator resistance also becomes critica...