Title of Thesis: THERMO-MECHANICAL ANALYSIS OF ENCAPSULATED BALL-WEDGE WIRE BONDS IN MICROELECTRONICS, USING RALEIGH-RITZ MODELING Krishna Kumar Jinka, Master of Science, 2006 Thesis directed By: Professor Abhijit Dasgupta Department of Mechanical Engineering This study addresses encapsulated wire bonds in chip-on-board (CoB) multi chip modules, which provide a low cost option for dealing with ...

objective roughness is the main parameter in interlocking bonding mechanism. yet there is no model designed to evaluate the effect of surface roughness on adhesion of coating materials in pharmaceutical sciences. materials and methods in this study polymethyl metacrylate spherical beads with different sizes were poured into 10 mm mold, then it was pressed by hand screw and finally heated to 141...

Composite action of any reinforced concrete member is only possible if sufficient bond strength exists between steel reinforcing bars and concrete, which can adequately transfer shear stress between them. Bond strength is a function of compressive strength of concrete and hence high strength concrete has higher bond strength [1-2]. Therefore required development length can be reduced. In order ...

Previous molecular dynamics simulations have shown that compression of silica glass surfaces occurs upon formation of an interface with a model crystal and that a structural change caused by this process is retained after glass and crystal are separated. The remnant structural modification caused by this stress was an increase in the concentration of siloxane bond angles less than 1508 in the n...

The fact that biological tissues are stable over prolonged periods of time while individual receptor-ligand bonds only have limited lifetime underscores the critical importance of cooperative behaviors of multiple molecular bonds, in particular the competition between the rate of rupture of closed bonds (death rate) and the rate of rebinding of open bonds (birth rate) in a bond cluster. We have...

Average stress during shear bond testing, and deformation behaviour during nano-indentation testing were calculated for the bonding area as a bonding site for copolymerization with resin composite in dentine bonding systems. First average stress was calculated in the bonding area between bovine dentine and composite resin. Secondly, the plastic deformation zone size was calculated using an elas...