This paper proposes, for low buildings, an integrated wall structure of a brick-stem-insulating layer, which plays a major part in both heat preservation and force bearing. The research team has tested the thermal performance of the structure, the results of which are satisfying. To further study the force-bearing performance, the paper carries out compressive tests of specimens of different st...

The ballistic response of the high strength, low alloy (HSLA-100) steel at ambient and temperatures of -400°C, -800°C and -1960°C is investigated in this work. Lambert-jonas equation is used to fit the experimental results into a curve. The effect of quenching on ballistic behavior of HSLA-100 is also studied. The experiments are conducted on 3mm thick rectangular specimens impacted by blunt ti...

PURPOSE To compile a survey of the longevity and reasons for failure of stainless steel crowns, amalgam, glass-ionomer, composite and compomer restorations in stress-bearing cavities of primary molars. METHODS This work reviewed the dental literature of 1971 up to July 2003 for longitudinal, controlled clinical studies and retrospective cross-sectional studies. Only studies investigating the ...

One of the most promising ways to produce a grain-refined microstructure in some steel materials is the thermomechanical processing route of subcritical recrystallization annealing of a cold-deformed martensite structure. In the present study, the microstructural evolutions and the associated recrystallization kinetics under various subcritical annealing heat treatment conditions are explored i...

In order to study pressed pile test and ultimate bearing capacity character of large-diameter steel pipe pile, based on two high-piled wharfs of Zhanjiang Port, pressed pile test and numerical simulation of three large-diameter steel pipe piles are analyzed in this paper. Anchored pile method is used to pressed pile test, and the curves of Q-s and ultimate bearing capacity are attained. Then th...

This work revealed the results of comparative surveys of the impact of formed surface layer TiN and CrN and two component surfaces layer TiN-steel and CrN-steel. The slide couple worked in conditions of lubricating the friction area with Lotos Syntetyk 5W/40 and Castrol GTX Magnatec 5W/40 engine oils. In the friction couple the counter sample was made from CuPb30 bearing alloy. The tribological...

in many structures, the applied lateral loads are comparable with gravity loads. these types of piles which are subject to high lateral load are usually divided into two categories including long and short piles. the general methods to estimate lateral bearing capacity of short and long piles are based on ultimate bearing capacity and allowable horizontal displacement respectively. in the prese...

The present study investigates the fracture toughness of FSW X80 HSLA steel welds. Weld cooling rate and peak temperature were varied among welds; indirectly manipulated through travel speed, rpm, weld preheat. Fracture was tested according to ASTM 1820 standard along centerline using surface-notched SEB specimen cooled −40 °C. Results demonstrate that CTOD has a strong inverse linear correlati...