A flexible proximity sensor fully fabricated by inkjet printing is proposed in this paper. The flexible proximity sensor is composed of a ZnO layer sandwiched in between a flexible aluminum sheet and a web-shaped top electrode layer. The flexible aluminum sheet serves as the bottom electrode. The material of the top electrode layer is nano silver. Both the ZnO and top electrode layers are depos...

Purpose: The main objective of this study was development of determination of phase fraction methodology in cast magnesium alloy containing aluminum and rare earth elements. Design/methodology/approach: The study was conducted on magnesium alloy containing 4 %wt. aluminum and 4 %wt. mixture of rare earth elements (mischmetal) in the as-cast condition. The mischmetal includes cerium, lanthanum, ...

The isothermal oxidation resistance of Al0.2Co1.5CrFeNi1.5Ti0.3 high-entropy alloy is analyzed and the microstructural evolution of the oxide layer is studied. The limited aluminum, about 3.6 at %, leads to the non-continuous alumina. The present alloy is insufficient for severe circumstances only due to chromium oxide that is 10 μm after 1173 K for 360 h. Thus, the aluminized high-entropy allo...

An Al/Stainless Steel/Al lamellar composite was produced by roll bonding of the starting sheets at 400 °C. Afterward, the roll bonded sheet was cut in half and the accumulative roll bonding (ARB) process at room temperature was applied seven times. As a result, the central steel layer fractured and distributed in the Al matrix among different layers introduced by the repetition of roll bonding ...

Overall fatigue strengths and hardness distributions of the aluminum alloy similar and dissimilar friction stir welding (FSW) joints were determined. The local fatigue strengths as well as local tensile strengths were also obtained by using small round bar specimens extracted from specific locations, such as the stir zone, heat affected zone, and base metal. It was found from the results that f...

Fatigue analysis of aluminum-alloy welded joints based on the linear elastic notch-stress approach is presented in this paper. The International Institute Welding proposes two variants approach, one for thick joints, i.e., with a plate thickness 5 mm or more, reference radius rref = 1 mm, using FAT71 design curve, and thin less than 0.05 FAT180 curve. In work, feasibility proposed S–N curves, o...