As orthopaedic and dental metallic implant materials, titanium and titanium alloys are widely used due to their relatively low modulus, good fracture toughness, excellent strenthto-weight ration, and superior biocompatibility and corrosion resistance (Long and Rack, 1998). They have become the first choice above all other candidate metallic implant materials such as Co-Cr-Mo alloys, stainless s...

The environmental radial distribution functions (RDFs) around Cu and Fe as well as the ordinary R D F of an as-quenched Al 6 5 Cu 2 0 Fe 1 5 alloy have been determined by anomalous x-ray scattering (AXS) and conventional x-ray diffraction techniques. The experimental information indicates that a strong directional dependence along the symmetrical axes exists for the Cu atoms but not for the Fe ...

In this research a Cu-Zn-Al alloy is produced by melting the raw materials in an electric resistance furnace and then pouring it into a steel mould. The optimum way to achieve the final analysis in the hypo-eutectoid range is determined and the influence of the alloying element, Ti on the grain size and the shape memory properties of the samples are investigated. Solution treatment (done at 850...

In the present work, the isothermal compression tests of Al–0.62Mg–0.73Si aluminum alloy were carried out by using the Gleeble-1500D thermo-simulation machine. The samples were tested in the temperature range of 410–510°C and strain rate range of 0.001–1 s−1. Based on the obtained stress–strain curves, the hot deformation behavior was presented. The constitutive relationship of Al–0.62Mg–0.73Si...

The precipitation and evolution of microstructure in a spray-cast Al-7034 alloy and a commercial wrought Al-2024 alloy were studied after equal-channel angular pressing (ECAP) using transmission electron microscopy and differential scanning calorimetry (DSC). Microstructural examination showed the grain sizes of both alloys were reduced to the range of ~0.3–0.5 μm through ECAP. The DSC analysis...

The partitioning behavior of W in a multicomponent Ni-based superalloy and in a ternary Ni–Al–W alloy is investigated using atom-probe tomography APT and first-principles calculations. APT observations indicate that whereas W partitions preferentially to the L12 -precipitates in the ternary alloy, its partitioning behavior is reversed in favor of the fcc -matrix in the multicomponent alloy. Fir...

specific strength, high specific stiffness, and many other advantages (Mordike et al., 2001). With the increased consciousness of energy saving and environmental protection, Mg alloys are becoming widely recognized as the candidates to replace steel and aluminium alloys in many fields, such as in vehicles and the electronics industry. Mg alloys are thus becoming known as new ‘green’ engineering...

the effect of t6 heat treatment on the microstructure and wear behavior of al-332 piston alloy containing 1.2wt% iron was investigated. the results showed that the t6 heat treatment changed the morphology of acicular eutectic si particles to a more spherical form. the heat treatment also reduced the average length and blunted the needle-like ?- phase intermetallics through dissolution and fragm...

friction stir processing was applied for fabricating an aluminum alloy based hybrid nano composite reinforced with nano sized al2o3 and micro sized graphite particles. a mixture of al2o3 and graphite particles was packed into a groove with 1 mm width and 4.5 mm depth, which had been cut in 5083 aluminum plate of 10 mm thick. packed groove was subjected to friction stir processing in order to im...

Effects of rapid heat transfer using a fluidized bed on the heat-treating response of Al-Si-Mg alloys (both unmodified and Sr modified) were investigated. The heating rate in the fluidized bed is greater than in conventional air convective furnaces. Particle size analyses of eutectic Si showed that the high heating rate during fluidized bed solution heat treatment causes faster fragmentation an...