Over the last two decades, many researchers have developed a variety of stainless steel-based medical implant types,taking full advantage of nanostructuring technologies. In this paper the application, fabrication and development of nanostructured stainless steel based materials with new composition for medical implants will be discussed. It is well established that application of severe plasti...

In this work the different contributions to the thermoelectric power (TEP) measurement during the dissolution process of M23C6 carbides in an X45Cr13 stainless steel have been evaluated. Thus, the influences of carbon and chromium contents in solid solution in the austenite, the austenite grain boundaries and the microstructure on the TEP have been determined.

Cost reduction and high efficiency are the mayor challenges for sustainable H2 production via proton exchange membrane (PEM) electrolysis. Titanium-based components such as bipolar plates (BPP) have the largest contribution to the capital cost. This work proposes the use of stainless steel BPPs coated with Nb and Ti by magnetron sputtering physical vapor deposition (PVD) and vacuum plasma spray...

High temperature deformation behavior of cast 310S stainless steel has been investigated in this study by performing tensile and compression tests at temperatures from 900 to 1200C. Rectangular ingots of which the dimensions were 350×350×100 in millimeter were cast using vacuum induction melting. Phase equilibrium was calculated using the FactSage®, thermodynamic software and database. Thermal ...

The present work is concentrated with the dry turning of AISI 304 Austenitic Stainless Steel (ASS). This paper presents the influence of cutting parameters like cutting speed, feed rate and depth of cut on the surface roughness of austenitic stainless steel during dry turning. A plan of experiments based on Taguchi’s technique has been used to acquire the data. An orthogonal array, the signal t...

Iron chromium oxide microspheres were generated by pulsed laser irradiation on the surface of two commercial samples of stainless steel at room temperature. An Ytterbium pulsed fiber laser was used for this purpose. Raman spectroscopy was used for the characterization of the microspheres, whose size was found to be about 0.2-1.7 μm, as revealed by SEM analysis. The laser irradiation on the surf...

Soft X-ray absorption spectroscopy (XAS) has been used to study the influence of Si ion implantation on the passive layer of AISI 304 stainless steel, as well as on its high-temperature oxidation behaviour. Ion implantation is a usual technique to improve the corrosion and oxidation resistance of steels. To study the effects of ion implantation on the room temperature corrosion behavior of AISI...

The effect of several Almen intensities of shot peening on the corrosion behavior, surface roughness, micro hardness profiles, and residual stresses of stainless steel AISI 316 L were investigated. Hydroxyapatite coating (HA) were applied to shot peened materials to improve their corrosion resistance. The corrosion behaviour were studied using potentiodynamic polarization. The electrochemical t...

Introduction The mechanical properties of austenitic stainless steels, including the low cyclic fatigue behavior have been a subject of numerous studies [1-8]. Nitrogen addition, in general, increases the fatigue strength by decreasing the stacking fault energy of austenitic stainless steels [6]. The stacking fault energy has a strong influence on the cross slip difficulty, thus it affects the ...