In order to investigate lattice defects of 18-8 stainless steel after solution, precipitation and resolution treatments, thin films prepared from bulk specimens after the heat treatments were examined by means of transmission electron microscopy. In addition, measurements of the internal friction, specific gravity and electrical resistivity as well as Huey corrosion tests were conducted. The ex...

The new superaustenitic stainless steel UNS S32654 (Avesta Sheffield 654 SMO) is proposed for condenser tubes in desalination and power plants. A number of tests illustrating its corrosion resistance in a variety of chloride containing environments are being reviewed in terms of pitting, crevice corrosion and stress corrosion cracking. Relevant mechanical and physical properties are described. ...

Electrochemical synthesis of poly ortho toludine (POTD) was achieved on Teflon coated cylindrical stainless steel electrodes with base diameter 2mm . Aniline in 2-propyl pentatonic acid solution was polymerized on the surface of stainless steel using cyclic voltametry technique. Adherent and red polymer films were obtained on the electrodes.. The corrosion inhibitive performance of POTD+2PPA , ...

introduction: the purpose of this in vitro study was to compare apical microleakage after obturation with nickel-titanium (niti) compared to stainless steel (ss) finger spreaders. materials and methods: eighty straight single-rooted human teeth were instrumented using step-back technique. the specimens were randomly divided into four groups. the two experimental groups (n=30) and the negative c...

The effect of chloride ions concentration on the electrochemical behavior of AISI 410 stainless steel in the simulated concrete pore (0.1 M NaOH + 0.1 M KOH) solution was investigated by various electrochemical methods such as Potentiodynamic polarization, Mott–Schottky analysis and electrochemical impedance spectroscopy (EIS). Potentiodynamic polarization curves revealed that increasing chlori...

The press formability of a dual-phase stainless steel sheet consisting of ferrite and austenite phases was estimated from a viewpoint of texture using plastic strain ratios (r-values). From the comparison of the mechanically obtained r-values by tensile test and the r-values calculated from the crystal orientation distribution functions (ODFs) of each phase, we found the ferrite phase contribut...

In this research work a series of tests were conducted in order to determine flank wear and cutting force FY on hard AISI 440 C martensitic stainless steel and SCM 440 alloy steels. The operating parameters are cutting speed, feed rate and a constant depth of cut to investigate the flank wear and cutting force. No cutting fluid was used during the turning process. The cutting tool used was CBN ...

Purpose: To evaluate the effect of carvacrol against Salmonella saintpaul biofilms on stainless steel surface. Methods: The effect of carvacrol on planktonic cells of S saintpaul was evaluated by determining the minimum inhibitory concentration (MIC) and minimal bactericidal concentration (MBC). The action of carvacrol on S. saintpaul biofilms on stainless steel surface was evaluated on establi...

PURPOSE To compile a survey of the longevity and reasons for failure of stainless steel crowns, amalgam, glass-ionomer, composite and compomer restorations in stress-bearing cavities of primary molars. METHODS This work reviewed the dental literature of 1971 up to July 2003 for longitudinal, controlled clinical studies and retrospective cross-sectional studies. Only studies investigating the ...

PURPOSE This study was conducted to evaluate the effects of full-coverage all-ceramic zirconia, lithium disilicate glass-ceramic, leucite glass-ceramic, or stainless steel crowns on antagonistic primary tooth wear. MATERIALS AND METHODS There were four study groups: the stainless steel (Steel) group, the leucite glass-ceramic (Leucite) group, the lithium disilicate glass-ceramic (Lithium) gro...