In this paper, Performance of three-level integrated ac–dc converter with Hysteresis Current Control Technique is presented. The proposed converter combines with the operation of the boost power factor correction and the three-level dc–dc converter. By the implementation of Hysteresis Current controller, the switching sequence is under controlled condition and the output voltage of the proposed...

This paper proposes a control method that can balance the input current of the three phase, three wire, Boost rectifier under unbalanced input voltage condition. The control objective is to operate the rectifier in the high power factor mode under normal operating condition but to give ovemdmg priority to the current balance function in case of unbalance in the input voltages. The inner loop im...

This paper concentrates on the control of hybrid fuelcell (FC)/energystorage distributed generation (DG) systems under voltage sag in distribution systems. The proposed control strategy makes hybrid DG system work properly when a voltage disturbance occurs in distribution system, and it stays connected to the main grid. This controller determines the supercapacitor power that should be generate...

In this paper, a robust sliding mode controller for the control of dc-dc buck converter is designed and analyzed. Dynamic equations describing the buck converter are derived and sliding mode controller is designed. A two-loop control is employed for a buck converter. The robustness of the sliding mode controlled buck converter system is tested for step load changes and input voltage variations....

To solve the large torque ripple and current harmonics, low DC bus voltage problems, a new control strategy is proposed for AC induction motor by using space vector pulse width modulation, so that the static and dynamic performance are improved. The system simulation experiment mode was established based on SVPWM to verify the effectiveness of the system control mode. It is showed that it can r...

This letter describes a zero-speed start-up method of a speed sensorless stator-flux-oriented direct vector-controlled induction motor drive with the help of a machine current model that does not use any speed signal. The machine starts smoothly with vector control at finite developed torque and then transitions to the standard direct vector-control mode with the voltage model signals as the sp...

This paper investigates the dynamic behavior of Gas Metal Arc Welding (GMAW) process for two types of power supplies –inverter and rectifier- for short circuit transfer mode. The large ripples on the rectifier power source are able to perturb the metal transfer mode. In this experimental work some operating points in the short circuit mode have been selected using an automatic pipeline welding ...

 Recently, special type of fuel cells has been developed that operates in a Dead End mode. Working in this condition, the Dead-End fuel cell is supplied withhydrogen almost at the same rate of consumption. It is noteworthy to mention thatall of the water transport mechanisms have been considered in this simulation.Water accumulation that is directly proportional to the cell current is of a grea...

using the facts controllers, such as static synchronous compensator (statcom), as it provides continuous reactive power, in the grid including wind turbine (wt) equipped with doubly fed induction generator, for improving voltage profile (under normal circumstances) and providing a transition ability from inductor generator transition state has been proposed. in this paper, in order to control t...