This paper presents a reduce roll vibration of the full vehicle model with passive suspension systems using vibration absorber to change the dynamic system matrix stat’s eigenvalue. Since using the controller system has been splurged and required to energy consuming, in this research the vehicle body roll vibration has been reduced and supplied vehicle stability using a vibration absorber for t...

This paper presents a study on dynamics modeling and control system design of a stewart platform using piezoelectric actuators, which has been developed at the Spacecraft Dynamics Control and Navigation Laboratory (SDCNLab), York University for vibration isolation. As an efficient mechanism of six degree-of-freedom (6-DOF), stewart platform is capable of isolating vibration of wide band range, ...

This application note describes the concept of measuring impact of an object using an accelerometer, microcontroller hardware/software and a liquid crystal display. Due to the wide frequency response of the accelerometer from d.c. to 400 Hz, the device is able to measure both the static acceleration from the Earth’s gravity and the shock or vibration from an impact. This design uses a 40g accel...

Vibration reduces the amplitudes of the tendon jerk response and the Hoffmann and stretch reflexes in the muscle exposed to the vibration, yet does not alter the time to task failure when the task involves exerting a submaximal force against a rigid restraint. Because the amplitude of the stretch reflex is greater when a limb acts against a compliant load than a rigid restraint, the purpose was...

Supine human response and vibration-suppression during whole-body vibration." MS (Master of Science) thesis, ii ACKNOWLEDGMENTS I would like to acknowledge the U.S. Army Aberdeen Test Center (ATC) for the use of the inertial sensors, the USA Army Research Lab (USAARL) for providing the litter, Dr. David Wilder for providing the long spinal board and cervical collar, Mr. Jonathan DeShaw for assi...

BACKGROUND About 20 to 50 percent of accidents are due to some forms of carelessness and mindedness. Studies suggested that vibration is one of the most important physical factors in human performance when traveling on any sort of vehicles. The aim of this study was to investigate the effect of vehicles vibration on cognitive performance (attention and concentration). METHODS The sample consi...

This paper describes a method for correcting the dynamically induced bias errors in wind tunnel model att i tude measurements using measured modal properties of the model system. At NASA Langley Research Center, the predominant instrumentation used to measure model attitude is a servo-accelerometer device that senses the model attitude with respect to the local vertical. Under smooth wind tunne...

Recently, piezoelectric energy harvesters (PEHs) have been paid a lot of attention by many researchers to convert mechanical energy into electrical and low level vibration. Currently, most of PEHs worked under high frequency and low level vibration. In this paper, we propose a micro cantilever generator based on the bonding of bulk PZT wafer and phosphor bronze, which is fabricated by MEMS tech...

Exposure to hand-transmitted vibration is usually assessed according to International Standard ISO 5349-1:2001 using the frequency weighting W(h). This paper compares eight frequency weightings that might be used to supplement or replace W(h). The comparison is based on a data from two databases, one containing over 7200 measured hand-arm vibration (HAV) spectra from a wide range of industrial ...