To compensate for changes in ambient temperature, thermal flow sensors are usually heated to a constant temperature above ambient temperature. This operating mode, however, requires an extra ambient-temperature sensor. Using a simple model, it is shown that for a two-dimensional thermal flow sensor, similar compensation may be obtained by using a constant heating power, thus eliminating the nee...

One of the effective methods to improve the thermal efficiency of solar collectors is using nanofluids as the coolant. The present study experimentally investigated the effect of SiO2/water nanofluid with 1% mass fraction on the performance of a symmetric collector, i.e. conical solar collector. The conical solar collector with 1 m2 area and normal to the earth was tested in Ahvaz, a city in th...

This paper describes a theoretical study to investigate the heat transfer characteristics of porous radiant burners. A one dimensional model is used to solve the governing equations for porous medium and gas flow before the premixed flame to the exhaust gas. Combustion in the porous medium is modeled as a spatially dependent heat generation zone. The homogeneous porous media, in addition to its...

In this paper, the cooling performance of water-cooled heat sinks for heat dissipation from electronic components is investigated numerically. Computational Fluid Dynamics (CFD) simulations are carried out to study the rectangular and circular cross-sectional shaped heat sinks. The sectional geometry of channels affects the flow and heat transfer characteristics of minichannel heat sinks. T...

A three-dimensional finite difference model was employed for the borehole ground heat exchanger to perform a thermal response test analysis using the parameter estimation technique. This allowed the groundwater velocity to be determined simultaneously together with the ground thermal conductivity and the borehole thermal resistance. It was found that the estimated groundwater velocity scattered...

outdoor experiments on a once-through single glazed solar air heater with perforated metal absorber plate were conducted to determine the practical effect of absorber plate porosity as well as suction air flow rate on the collector thermal efficiency and its total pressure drop. three aluminum absorber plates were made perforated by drilling circular holes with different diameter/pitch ratios i...

Resistance spot welding is a very complicated process involving electro-magnetic, thermal, fluid flow, mechanical and metallurgical variables. Since weld nugget area is close and unobservable with experimental means, numerical methods are mainly used to reveal the nugget formation mechanism. So far, heat transfer behaviors in the weld nugget have been systematically studied with traditional ele...

The oscillating heat pipe (OHP) is a new member in the family of heat pipes, and it has great potential applications in energy conservation. However, the fluid flow and heat transfer in the OHP as well as the fundamental effects of inner diameter on them have not been fully understood, which are essential to the design and optimization of the OHP in real applications. Therefore, by combining th...

A control system using a low-drift power-feedback signal was implemented applying thermal waves, giving a sensor output independent of resistance drift and thermo-electric offset voltages on interface wires. Kelvin-contact sensing and power control is used on heater resistors, thereby inhibiting the influence of heater resistance drift. The thermal waves are detected with a sensing resistor usi...

thermal modeling of an automotive cabin was performed in this paper to predict the inside cabin air temperature. to implement this task, thermal and ventilation loads were estimated and the mass and energy balance conservation equations for dry air and water vapor with considering a new parameter (air circulation ratio) as well as the balance equations of internal components of a cabin were der...