Abstract - Use of efficient signal processing tools (SPTs) to extract proper indices for fault detection in induction motors (IMs) is the essential part of any fault recognition procedure. The Part1 of the two parts paper focuses on Fourier-based techniques including fast Fourier transform and short time Fourier transform. In this paper, all utilized SPTs which have been employed for fault fete...

in this work dynamic recrystallization behavior of aisi 403 martensitic stainless steel was studied using hot compression tests over temperature range of 900 c -1200 c and strain rate range of 0.001 s-1 - 1 s-1. the obtained flow curves showed that the hot compression behavior of the alloy is controlled by dynamic recrystallization. the flow stress and strain corresponding to the critical, pe...

nowadays, compressible flow transmission pipelines are used in many industrial processes. pipelines in chemical processes, gas turbine power plants, natural gas transmission lines, and high pressure steam transmission pipelines are some industrial examples. therefore, learning the manner of treatment of a transient compressible fluid flow in pipelines with junctions and branches is important. i...

A plane subsonic jet was subjected to periodic oscillations in the near nozzle region by a twin vane system. During excitation, the jet was found to spread significantly and entrain mass much more than its steady counterpart. Time averaged static pressure measured in the flow field with a disc probe exhibited prominent well defined suction regions different from that of a steady jet.

Various research groups across the globe have developed models for engine condition monitoring and fault diagnosis based on the data from steady state performance measurements over the last two decade. However, these performance data are not amenable for easy collection in some situations and some of the data may show little performance deviation at the steady state conditions of operation. In ...

Nozzle shape plays a key role in determining the flow pattern in the mold of the continuouscasting process under both steady-state and transient conditions. This work applies computational models and experiments with a one-third scale water model to characterize flow in the nozzle and mold to evaluate well-bottom and mountain-bottom nozzle performance. Velocities predicted with the three-dimens...

In this paper, we model DCCP congestion control mechanism and RED as independent discrete-time systems using fluid-flow approximation. By interconnecting DCCP connections and RED routers, we model the entire network as a feedback system called DCCP/RED. We then analyze the steady state performance and the transient state performance of DCCP/RED. Specifically, we derive the packet transmission r...

effect of small al additions, from 0.14% to 0.31% ai, on the hot deformation behavior of low carbon steels containing 1%cu-1.2%mn was investigated in the temperature range of 750-800•c over the strain rate range of 1o.3.1o.1s•1 by a hot compression testing machine. the flow curves obtained, exhibited typical characteristics of dynamic recovery type of softening mechanism, and the critical strai...