In manufacturing, thermal spray technology encompasses a group of coating processes that provide functional surfaces to improve the performance of the components and protect them from corrosion, wear, heat and other failings. Many types and forms of feedstock can be thermal sprayed, and each requires different process conditions and life cycle preparations. The required thermal energy is genera...

Submitted for the DFD10 Meeting of The American Physical Society Coaxial twin-fluid atomization with pattern air gas streams CHIN HEI NG, ALBERTO ALISEDA, University of Washington — Coaxial twin-fluid atomization has numerous industrial applications, most notably fuel injection and spray coating. In the coating process of pharmaceutical tablets, the coaxial atomizing air stream is accompanied b...

Angle-independent coloured films with superhydrophobicity were fabricated from quasi-amorphous arrays of monodispersed fluorinated silica nanoparticles via one-step spray coating. The film exhibited a high contact angle (>150°) and a low roll-off angle (~2°) and the colour could be tuned to blue, green and moccasin by varying the size of the nanoparticles.

The spray drying technique was used to obtain the roxithromycin containing microcapsules with high taste masking efficiency. Eudragit L30D-55 was chosen as a barrier coating. The taste was evaluated by an electronic tongue, and taste-masking effect in water lasted at least several dozen hours.

The host response to calcium silicate ceramic coatings is not always favorable because of their high dissolution rates, leading to high pH within the surrounding physiological environment. Recently, a zinc-incorporated calcium silicate-based ceramic Ca2ZnSi2O7 coating, developed on a Ti-6Al-4V substrate using plasma-spray technology, was found to exhibit improved chemical stability and biocompa...

Amultifunctional material, strontium zirconate, SrZrO3, studied in literatures as a dielectric ceramics, thermal barrier coating, proton-conductor, and luminescent material was sprayed by a water-stabilized plasma torch WSP 500. Stainless steel and plain carbon steel were used as substrates. Coatings with thickness of 1 to 2 mm were produced, whereas the substrates were preheated over 450 °C. T...

In this paper the effect of plasma spray parameters, atomizing gas and substrate preheat temperature on microstructure and phase composition of YSZ coatings produced by SPPS process have been investigated. The experimental results showed that increasing the power of plasma, using hydrogen as the precursor atomizing gas and increasing substrate preheat temperature decrease the amount of non-pyro...

Novel Ca-Si-Ti-based sphene (CaTiSiO5) ceramics possess excellent chemical stability and cytocompatibility. The aim of this study was to prepare sphene coating on titanium alloy (Ti-6Al-4V) for orthopaedic applications using the plasma spray method. The phase composition, surface and interface microstructure, coating thickness, surface roughness and bonding strength of the plasma-sprayed sphene...

In various industries such as power plants, ultrasonic non-destructive testing (NDT) is widely used because of cost effectiveness and sub-surface defect/flaw detection capability. Piezoelectric films made of sol-gel composites could be useful as ultrasonic transducers due to high tempearature durability, reasonable signal strength, curved surface suitability, relatively low center frequency suc...

Essential oils from four plants, i.e. geranium, rosa, lemon and mint were tested for their activity in vitro and in vivo against Rhizoctonia solani and Fusarium oxysporum f. sp. phaseoli, the cause of root rot and wilt of beans. In vitro, they were found to have an inhibitory effect against the mycelial growth of R. solani and F. oxysporum f. sp. phaseoli. Complete inhibition in fungal growth w...