In the present paper the applicability of state and rate dependent friction laws in describing the phenomena of high speed slip at metal-on-metal interfaces is investigated. For the purpose of model validation, results of plate-impact pressure-shear friction experiments were conducted by Irfan in 1998 and Irfan and Prakash in 2000 using a Ti6Al4V and Carpenter Hampden tool-steel tribo pair are ...

We model seismic and aseismic slip on the Japan megathrust in the area of theMw9.0, 2011 Tohoku-Oki earthquake based on daily time series from 400 GPS stations of the GEONET network and campaign measurements of six sea floor displacements. The coseismic and postseismic slip distributions are inverted simultaneously using principal component analysis-based inversion method (PCAIM). Exploring a w...

The 11 March 2011 Mw9.0 Tohoku-Oki earthquake was recorded by an exceptionally large amount of diverse data offering a unique opportunity to investigate the details of this major megathrust rupture. Many studies have taken advantage of the very dense Japanese onland strong motion, broadband, and continuous GPS networks in this sense. But resolution tests and the variability in the proposed solu...

Low-frequency earthquakes (LFEs) are small repeating earthquakes that occur in conjunction with deep slow slip. Like typical earthquakes, LFEs are thought to represent shear slip on crustal faults, but when compared to earthquakes of the same magnitude, LFEs are depleted in high-frequency content and have lower corner frequencies, implying longer duration. Here we exploit this difference to est...

The experimental study introduces an unload-induced direct-shear model to investigate the frictional slip of a layer of simulated granular gouges induced by the combination of a decreasing normal stress and a constant shear stress. A frictional equilibrium state of the gouge layer is initially established under fixed normal and shear stresses. The normal stress is proposed to decrease at a cons...

This paper describes a numerical investigation of seismicity induced during injection into a single, isolated fracture. A model was developed and used that couples (1) fluid flow and (2) rate and state friction. Rate and state friction theory describes how friction on a fault depends on both sliding velocity and past sliding history. Rate and state friction is used widely in earthquake modeling...

Falls due to slips are prevalent in everyday life. The purpose of this study was to determine the reactive recovery responses used to maintain dynamic stability during an unexpected slip, establish the time course of response adaptation to repeated slip perturbations, and distinguish the proactive strategies for negotiating a slippery surface. Twelve young adults participated in the study in wh...

Many experiments have measured the effect of force on the dissociation of single selectin bonds, but it is not yet clear how the force dependence of molecular dissociation can influence the rolling of cells expressing selectin molecules. Recent experiments using constant-force atomic force microscopy or high-resolution microscopic observations of pause-time distributions of cells in a flow cham...

On microstructured hydrophobic surfaces, geometrical patterns may lead to the appearance of a superhydrophobic state, where gas bubbles at the surface can have a strong impact on the fluid flow along such surfaces. In particular, they can strongly influence a detected slip at the surface. We present two-phase lattice Boltzmann simulations of a flow over structured surfaces with attached gas bub...

Abstract Recent field studies provide evidence of fault slip-rate variability over time periods 10–100 k.y., yet researchers do not know how processes internal to the system (e.g., reorganization) impact records slip rates. In this study, we directly observed fault-system evolution and measured histories within a scaled physical experiment dextral strike-slip 15° restraining bend representative...