Introduction: To evaluate and compare shear bond strength of self-cure and  light-cure composites using a universal bonding system. Materials and Methods: Superficial coronal dentin of 62 intact extracted  premolars was exposed and bonding agent (All-Bond Universal) was applied over the  dentin surface according to the manufacturer instruction (self-etch mode). Then  samples were distribut...

Biomass tensile and shear ultimate failure stresses were measured with the aim of identifying biomass ‘‘weakest mode of failure’’ or ‘‘natural fracture point’’ as a basis for future grinder designs. Switchgrass (Panicum virgatum L.) ultimate stresses were determined for Alamo and Kanlow varieties over ranges in maturity and moisture content. Alamo had greater ultimate tensile stress than Kanlow...

Shear banding is a ubiquitous phenomenon of severe plastic deformation, and damage accumulation in shear bands often results in the catastrophic failure of a material. Despite extensive studies, the microscopic mechanisms of strain localization and deformation damage in shear bands remain elusive due to their spatial-temporal complexities embedded in bulk materials. Here we conducted synchrotro...

In reinforced concrete design, there are situations where transfer of shear across a specific plane needs to be considered. Examples of such situation include corbels, bearing shoes, ledger beam bearing, and a host of connection between precast concrete elements. In this study, the shear transfer behavior of reinforced concrete is investigated experimentally by conducting test on 6 precracked p...

Dynamic recrystallization (DRX) is almost universally observed in the microstructure of adiabatic shear bands. It is usually admitted that DRX results from the large temperatures that develop in the band along with very high local strains. This paper reports the observation of dynamically recrystallized nanograins in Ti6Al4V alloy specimens that were impact loaded to only half the failure strai...

Gecko adhesion has become a paradigmatic example of bio-inspired engineering, yet among the many gecko-like synthetic adhesives (GSAs), truly gecko-like performance remains elusive. Many GSAs have previously demonstrated one or two features of the gecko adhesive. We present a new wedge-shaped GSA that exhibits several gecko-like properties simultaneously: directional features; zero force at det...

It is well known that joints or fissures have an important effect on the failure mechanism of natural rocks. Previously, many numerical and experimental papers been carried out to study strength anisotropy characteristics jointed However, few studies nonpersistent rock masses with different persistence, especially for in three dimensions. In present study, a 3D mass inclinations (θ) persistence...

Plug failures have been observed in three-sheet spot welds, where the weld nugget did not penetrate into outer sheet. Such solid-state bonds were found to be formed as a result of high contact pressure and temperature during welding. The strength single welds was studied combination (0.61 mm DX54 on two 1.21 DP600) with penetrations thin sheet below 40%. static evaluated by tensile shear, cross...