The conceptual design of parallel robots can be dated back to the time when Gough established the basic principles of a device with a closed-loop kinematic structure (Gough 1956), that can generate specified position and orientation of a moving platform so as to test tire wear and tear. Based on this principle, Stewart designed a platform for use as an aircraft simulator in 1965 (Stewart 1965)....

In order to improve control performance and eliminate steady, a coupling compensation for 6-DOF parallel robot is presented. Taking dynamic load Tank Simulator as the research object, this paper analyzes the coupling of 6-DOC parallel robot considering the degree of freedom of the 6-DOF parallel manipulator. The coupling angle and coupling velocity are derived based on inverse kinematics model....

This paper provides an estimation model for calibrating the kinematics of manipulators with a parallel geometrical structure. Parameter estimation for serial link manipulators is well developed, but fail for most structures with parallel actuators, since the forward kinematics is usually not analytically available for these. We extend parameter estimation to such parallel structures by developi...

A N−1 wire-driven parallel robot is a robot for which all the N ≥ 3 wires are connected at the same point of the platform, allowing to control the location of this point. We are interested in the positioning accuracy of such a robot. If the wires are not elastic we show that the influence on the accuracy of the co-location errors of the wire anchor points on the platform is moderate, although a...

Accuracy of tracking and robustness are very important specifications in control of parallel robots. Classical control methods could not satisfy these requirements in parallel robots, simultaneously. Sliding mode control solves problems of accurate tracking, but it is not robust enough because of influence of chattering phenomena. Implementation of fuzzy logic in sliding mode enhances robustnes...

In this paper, the authors study the kinematic isotropic configuration of spatial cable-driven parallel robots by means of four different methods, namely, (i) symbolic method, (ii) geometric workspace, (iii) numerical workspace and global tension index (GTI), and (iv) numerical approach. The authors apply the mentioned techniques to two types of spatial cable-driven parallel manipulators to obt...

This paper presents a systematic load identification procedure for a class of parallel robot manipulators. It is considered as a regular dynamic robot identification problem since the load is rigidly fixed on the robot-platform. The challenge is that the estimation must be based only on the measurements obtained through sensors in the robot actuators. The load identification procedure is exempl...

This paper presents design and kinematic analysis for a cable-driven parallel robotic (CDPR) manipulator with four cables, The CDPR manipulator produces a planar motion including two translational and one rotational degrees of freedom. To move the end-effector of CDPR, its kinematic structure is analyzed and the inverse kinematics is formulated in the closed-form solution. The experimental test...

We present several prototypes of wire-driven parallel robots that we have recently designed and which use two different actuation schemes. Two of them have been completed and submitted to extensive tests. These tests have allowed to determine interesting open problems related to kinematics that are presented.