Stress perturbations influence earthquake recurrence and are of fundamental importance to understanding the earthquake cycle and determining earthquake hazard. The large population of repeating earthquakes on the San Andreas fault at Parkfield, California, provides a unique opportunity to examine the response of the repeating events to the occurrence of moderate earthquakes. Using 187 M 0:4 to ...

A total of 72 participants estimated products of complex multiplications of two-digit operands (e.g., 63 x 78), using two strategies that differed in complexity. The simple strategy involved rounding both operands down to the closest decades (e.g., 60 x 70), whereas the complex strategy required rounding both operands up to the closest decades (e.g., 70 x 80). Participants accomplished this est...

We introduce a computational method to directly relate diffusivities to the microscopic behavior of the adsorbed molecules. We apply this method to gases in an MFI-type molecular sieve, the reference system in this field. Transitions in the number and nature of adsorption sites result in temporary local increases in the diffusion. This occurs at different loadings in each of the x, y, and z dir...

Environmental control during transfer between instruments is required for samples sensitive to air or thermal exposure to prevent morphological or chemical changes prior to analysis. Atom probe tomography is a rapidly expanding technique for three-dimensional structural and chemical analysis, but commercial instruments remain limited to loading specimens under ambient conditions. In this study,...

Anaerobic digestion can be used to degrade food waste and recover energy. Methane is a biogas that can be efficiently converted in electricity. Organic loading rate, temperature, time, pH, carbon to nitrogen ratio are important factors to be operated in the bioreactors and still are challenges in this process to increase biogas production. It has been reviewed the single phase and two-stage bio...

Plasticity-induced, roughness-induced and oxide-induced crack closures are reviewed. Special attention is devoted to the physical origin, the consequences for the experimental determination and the prediction of the effective crack driving force for fatigue crack propagation. Plasticity-induced crack closure under plane stress and plane strain conditions require, in principle, a different expla...

The Footscan platform is a useful tool for plantar pressure measurement. However, there is still controversy over whether or not the platform should be covered by top-layer during the test. This study was designed to compare the reliability of the Footscan platform and identify the differences of the foot loading parameters between without top-layer (WOT) and with top-layer (WT) protocols. Meas...

Mechanisms of energy dissipation during solid-solid and solid-liquid friction are discussed. A conservative van der Waals adhesion force, when combined with surface imperfectness, such as deformation, leads to adhesion hysteresis (AH). When an asperity slides upon a substrate, the substrate is subjected to a loading-unloading cycle, and energy is dissipated due to the AH. Another mechanism, whi...

BACKGROUND The fluid load support fraction (W(F)/W(T)) can be used to define the mechanical contribution of the interstitial fluid (W(F)) to the total force (W(T)) in the deformation of cartilage. Traditionally, W(F)/W(T) is calculated using complex experimental setups or time-consuming micromechanical poroelastic Finite Element (FE) simulations. AIM To define and validate a fast and efficien...

In this study, two short precast concrete columns and two cast-in-situ concrete columns were tested under cyclic loads. It was shown that the sleeve grouted connection was equivalent to the cast-in-situ connections for short columns when the axial compression ratio was 0.6. In order to determine the influence of the axial compression ratio and the shear-span ratio on the shear capacity of the h...