Delamination is one of the most common failure modes in composite structures. In the case of in-plane compressional loading, delamination of a layered flat structure can cause a local buckling in delaminated area which subsequently affects the overall stiffness of the initial structure. This leads to an early failure of the overall structure. Moreover, with an increase in load, the delaminated ...

In this research effort, the generalized warping and distortional problem of straight or horizontally curved composite beams of arbitrary cross section, loading and boundary conditions is presented. An inclined plane of curvature is considered. Additionally, the stiffness of diaphragmatic plates has been introduced in the formulation in order to compare with the case where rigid diaphragms are ...

In this paper the buckling coefficient of FGM rectangular plates calculated by the new version of differential quadrature method (DQM). At the first the governing differential equation for plate has been calculated and then according to the new version of differential quadrature method (DQM) the existence derivatives in equation , convert to the amounts of function in the grid points inside of ...

The buckling analysis of rectangular laminated composite plates with an edge delamination under in-plane compressive loading is performed using the finite element method. Such a plate may be considered as a simplified model of stiffener plates of a stiffened panel. The buckling load and buckling mode are obtained by solving an eigenproblem. In an unconstrained analysis, physically inadmissible ...

In ergonomics research, two-dimensional (2-D) biomechanical models are often used to study the mechanical loading of the low back in lifting movements. When lifting movements are asymmetric, errors of unknown size may be introduced in a 2-D analysis. In the current study, an estimation of these errors was made by comparing the outcome of a 2-D analysis to the results of a recently developed and...

This paper describes a system for the study of the relation between structure and applied strain in thermoplastic polyurethane elastomers using the Australian National Beamline Facility at the Photon Factory, KEK, Tsukuba, Japan. The system uses the sagittal focusing monochromator at beamline 20B to provide a high-intensity focused beam which then falls on the specimen mounted in a miniature te...

This study documented three-dimensional spinal loading associated with asymmetric lifting while using either one or two hands to perform the task. Lift asymmetry was defined as a function of the load origin relative to the sagittal plane of the body. Lifts occurred at 0, 30, or 60 degrees off the sagittal plane on both sides of the body (lifting from the right and from the left relative to the ...

Ergonomic measures have been found to reduce load-related trouble from the neck-and-shoulders during visual display unit (VDU) work. An important question is the height at which the screen should be placed to give the lowest possible load. Should it be placed at eye-level or below? The aim of the present study was to investigate whether there was any difference in external loading moments of fo...