نتایج جستجو برای: hydraulic resistances
تعداد نتایج: 34353 فیلتر نتایج به سال:
Teed lines are widely used in rural power networks in China. The paper theoretically analyzes the voltages and currents when a single line-to-ground fault occurs, constructs a new mathematical model for fault location on the teed lines, performs corresponding MATLAB simulations. Simulation results show that currents near the source (bus M) are almost independent of fault positions and fault res...
Hydraulic calculations and mathematical modelling of open flows in river channels keep still being among the most topical hydro-engineering today’s problems terms practice. While solving them, independently on research topic purpose, methods used, a number simplifications assumptions are usually accepted applied. Moreover, there is range methodological, structural, parametric uncertainties, whi...
The pressure resistances of the spores of six Bacillus strains were examined at 5 to 10(deg)C and were compared with their heat resistances. The pressure treatments (at 981 MPa for 40 min and at 588 MPa for 120 min) did not inactivate the spores of B. stearothermophilus IAM12043, B. subtilis IAM12118, and B. licheniformis IAM13417. However, these spores had large differences in heat resistance....
The minimum resistance of expiratory Heidbrink-type value has been assessed by determining the pressure decrease across the values at a flow rate of 30 litre min--1. The average resistance of 70 valves currently in clinical use was 318 Pa at that flow rate and about 44% had resistances greater than the limit of 294 Pa previously suggested. The resistances obtained in new valves were either simi...
An algorithm for the calculation of the resistance between two arbitrary nodes in an arbitrary distance-regular resistor network is provided, where the calculation is based on stratification introduced in [1] and Stieltjes transform of the spectral distribution (Stieltjes function) associated with the network. It is shown that the resistances between a node α and all nodes β belonging to the sa...
[1] Hydraulic tomography is a cost-effective technique for characterizing the heterogeneity of hydraulic parameters in the subsurface. During hydraulic tomography surveys a large number of hydraulic heads (i.e., aquifer responses) are collected from a series of pumping or injection tests in an aquifer. These responses are then used to interpret the spatial distribution of hydraulic parameters o...
A method has been developed by which flow to each lung, as well as pulmonary artery and left atrial pressures can be measured and varied at will. Vascular resistances were determined over a wide range of these variables. Both pressures have a marked effect on vascular resistances; the higher either pressure, the lower the resistances. This effect is most marked at low levels of pressure and flo...
INTRODUCTION: The calculation of Manning n values has been of interest since the Manning equation was presented in the late 1800s (Henderson, 1966). While estimation of n vahm for normal channels has been fairly well standardized, the estimation of n values in areas of dense vegetation continues to be subject to large variations depending on the experience of the engineer and the perceived dens...
Trees face the dilemma that achieving high plant productivity is accompanied by a risk of drought-induced hydraulic failure due to a trade-off in the trees' vascular system between hydraulic efficiency and safety. By investigating the xylem anatomy of branches and coarse roots, and measuring branch axial hydraulic conductivity and vulnerability to cavitation in 4-year-old field-grown aspen plan...
نمودار تعداد نتایج جستجو در هر سال
با کلیک روی نمودار نتایج را به سال انتشار فیلتر کنید