The present work is carried out to investigate heat transfer and friction factor characteristics of fluid (air) flow through turbulent channel i.e. parallel plate heat exchanger for different geometry and designs parameters, with a bottom plate applied to uniform constant heat flux thermal boundary condition, and upper plate is provided with a insulated condition. The fluid domain is designed u...

A boundary layer analysis is presented for the mixed convection past a vertical plate in a porous medium saturated with a nanofluid in the presence of variable viscosity effect. The governing partial differential equations are transformed into a set of similar equations and solved numerically by an efficient, implicit, iterative, finite-difference method. A parametric study illustrating the inf...

In the present analysis an unsteady laminar forced convection water boundary layer flow is considered. The fluid properties such as viscosity and Prandtl number are taken as variables such that those are inversely proportional to temperature. By using quasi-linearization technique the nonlinear coupled partial differential equations are linearized and the numerical solutions are obtained by usi...

The aim of this paper is to present non-similar solutions of a steady laminar compressible boundary layer flow past a long thin circular cylinder including the effects of wall enthalpy and surface mass transfer. The governing equations along with the boundary conditions are first converted into dimensionless form by a non-similar transformation, and then the resulting system of coupled non-line...

Several researches dealing with the single-phase forced convection heat transfer inside micro channels have been published in the past decades. The performance of liquid flow has been proved that agree with the conventional correlations very well (Yang and Lin [2007]). However, owing to the low heat transfer coefficient of gaseous flow, it is more difficult to eliminate the effects of thermal s...

The two-dimensional magnetohydrodynamic (MHD) stagnation-point flow of electrically conducting non-Newtonian Casson fluid and heat transfer towards a stretching sheet in the presence of mass transfer and chemical reaction is considered. Implementing similarity transformations, the governing momentum, and energy equations are transformed to self-similar nonlinear ODEs and numerical computations ...

A theoretical investigation is performed for studying the flow of heat transfer characteristics of Sakiadis and Blasius flow of magnetohydrodynamic Maxwell fluid with thermal radiation. We also incorporated the Cattaneo-Chirstov heat flux model to control the heat transfer phenomena. Numerical solutions are carried out by using Shooting technique. The effects of various governing parameters on ...

In this paper, heat and mass transfer in the unsteady squeezing flow between parallel plates is analyzed using a perturbation-iteration algorithm. The similarity transformation is used to transform the governing partial differential equations into ordinary differential equations, before being solved. The solutions of the velocity, temperature and concentration are derived and sketched to explai...

–Friction stir welding is a solid state welding technology used for welding low melting point metals, such as Al, Mg and its alloys. Later welding was conducted on dissimilar metals which also produced a better defect free joint. Tool design and welding parameters contributes a major role for producing a better weld. Material flow and friction heat are the factors that the internal factor for t...

using of nanofluids and ducts with corrugated walls are both supposed to enhance heat transfer, by increasing the heat transfer fluid conductivity and the heat transfer area respectively. use of a diverging duct with a jet at inlet section may further increase heat transfer by creating recirculation zones inside the duct. in this work two-dimensional incompressible laminar flow of a nanofluid e...