Microsilica concrete was prepared with a water-binder ratio of 0.35. Microsilica was used as a 10% replacement of cement by weight. Cylinder and cube specimens were cast for testing different hardened properties of the concrete. Three curing methods such as water curing, wrapped curing, and dry-air curing were applied at 20±2 C to cure the cylinder and cube specimens until the 0 day of testing....

Refractive index control of benzocyclobutene (BCB 4024-40) is achieved by facilitating different conditions during the thermal curing of BCB film. Refractive index (RI) change of 1.49% is obtained with curing of BCB film using an oven, while the RI change is 0.1% when the BCB is cured using a hotplate. The two different curing methods exhibit a temperature dependent refractive index change of t...

As regards if curing stops for some time and then resumes again, then strength gain will also stop and reactive, in this study with choose suitable curing conditions after improper first curing (recurring) for normal and silica-fume concrete, Effect of this curing conditions on strength and permeability was investigated. The results from tests such as compressive strength, capillary water absor...

PURPOSE The aim of this study was to compare postoperative sensitivity following placement of posterior composite restorations using the fast- or step-curing modes of an LED curing light. MATERIALS AND METHODS Thirty patients participated, with each having two homologous contralateral posterior teeth with Class II carious lesions. One restoration was cured using the fast-curing mode of the LE...

present research involves the complete simulation of pultrusion manufacturing process of glass/polyester composites. for that purpose, the curing process is divided to two liquid and gel-solid phases. the physical characteristics of the resin consist of specific heat, viscosity and coefficient of heat transfer changes with variations of temperature and increasing the degree of curing process (α...

People experience various lights in daily life, such as sunlight through leaves and candle light. However, digital contents shown in common LCDs cannot express these impressive lights. In this paper, we propose a novel display technique, AugmentedBacklight, which can express impressive lights in the real world by expanding the LCD backlight. The system mainly consists of a transparent LCD, a sc...

The purpose of this study was to analyze the curing behavior of a nanocomposite by assessing in real time the degree of cure at depths of 2 mm and 6 mm. The variation of hardness with depth, shrinkage stress, and curing time until gelation with 16 curing regimes was further investigated using one halogen and three LED curing units. In the present study, it was shown that the soft-start polymeri...

PURPOSE The objective of this study was to compare the light transmittance of zirconia in different thicknesses using various light curing units. MATERIALS AND METHODS A total of 21 disc-shaped zirconia specimens (5 mm in diameter) in different thicknesses (0.3, 0.5 and 0.8 mm) were prepared. The light transmittance of the specimens under three different light-curing units (quartz tungsten ha...