Single crystal 6H-SiC wafers with 4° off-axis [0001] orientation were irradiated with carbon ions and then annealed at 900 °C for different time periods. The microstructure and surface morphology of these samples were investigated by grazing incidence X-ray diffraction (GIXRD), scanning electron microscopy (SEM), and transmission electron microscopy (TEM). Ion irradiation induced SiC amorphizat...

Progressive radial cracking of a clamped plate subjected to crack-face closure is studied. The material behavior is assumed to be elastic-brittle. The cracks are assumed to be relatively long in the sense that the three-dimensional contact problem can be described via a statically equivalent two-dimensional idealization. The number of cracks is supposed large enough to permit a quasi-continuum ...

The time dependence of fracture has two sources: (1) the viscoelasticity of material behavior in the bulk of the structure, and (2) the rate process of the breakage of bonds in the fracture process zone which causes the softening law for the crack opening to be rate-dependent. The objective of this study is to clarify the differences between these two influences and their role in the size effec...

It is an effective way to improve the flexural behavior of reinforced concrete (RC) members by externally bonded carbon fiber reinforcement polymer (CFRP) laminates on the soffit of the members. However, there is little investigation on flexural performance of RC beam flexurally strengthened by side-bonded FRP laminates. To investigate the flexural behavior of RC beams side-bonded CFRP laminate...

Cracks are an essential characteristic of reinforced concrete (RC) construction. Serviceability and durability, however, require a reasonable limitation the maximum crack width. The prediction width RC, is not trivial has been much debated over past decades. This article starts with fundamental comparison basic procedures for determining width, namely using mechanical or calibrated model. Follo...

An advanced, waveform based acoustic emission (AE) system was used to study the initiation of transverse matrix cracking in cross-ply graphite/epoxy (gr/ep) composites. The AE signals were detected with broad band, high fidelity sensors, and digitized for analysis. Plate wave propagation analysis was used to discriminate noise signals from those generated by cracks. The noise signals were confi...