This study is focused on synthesis of nano-colloidal silica via alkaline water glass solution. Sodium ions of water glass were removed by cation exchanging in a resin column to obtain the silicic acid which was titrated to the solution of sodium silicate. Concentration of the colloidal silica and pH value of the solutions were controlled using different concentrations of alkaline sodium silicat...

Spatial confinement of a near-critical medium changes its fluctuation spectrum and modifies the corresponding order parameter distribution, resulting in effective, so-called critical Casimir forces (CCFs) acting on the confining surfaces. These forces are attractive for like boundary conditions of the order parameter at the opposing surfaces of the confinement. For colloidal particles dissolved...

In this work, porous nanoparticles of ferrite cobalt were prepared by dissolving CoCl2.6H2O and FeCl3 in ethylene glycol in a hydrothermal process. Using ethylene glycol instead of DI water as a solvent would cause to provide porous structure of ferrite cobalt. 0.05 ml of colloidal fluid of fabricated nanostructure was injected on interdigitated electrodes (IDE) on a printed circuit board (PCB)...

It is very important in the design of a drying system is to evaluate sticking behaviour of the materials goes under drying. A new approach to the sticking issue is applied in this study by carrying out a sticking test for the liquid associated with the materials under study. It was found that the liquid bridge is responsible of the initial sticking of the materials to the contact surface and th...

this study is focused on synthesis of nano-colloidal silica via alkaline water glass solution. sodium ions of water glass were removed by cation exchanging in a resin column to obtain the silicic acid which was titrated to the solution of sodium silicate. concentration of the colloidal silica and ph value of the solutions were controlled using different concentrations of alkaline sodium silicat...

We prepared 0.1 wt%-30 wt% Pd-loaded Co3O4 by a colloidal mixing method and investigated the sensing properties of a Pd-loaded Co3O4 sensor element, such as the sensor response, 90% response time, 90% recovery time, and signal-to-noise (S/N) ratio, toward low nitric oxide (NO) gas levels in the range from 50 to 200 parts per billion. The structural properties of the Pd-loaded Co3O4 powder were ...

I have studied the effects of polydispersity on the phase behaviour of suspensions of PMMA colloidal spheres on their own and in the presence of non-adsorbed polymer. I systematically explored the volume fraction–polydispersity (φ − σ) phase behaviour of hard spheres (with radii R =167, 244, 300 and 303nm) through direct observations and crystallography measurements. I observed normal crystalli...

The current work presents the results of an experimental study of the effects of the location of gold additives on the performance of combustion-generated tin dioxide (SnO(2)) nanopowders in solid state gas sensors. The time response and sensor response to 500 ppm carbon monoxide is reported for a range of gold additive/SnO(2) film architectures including the use of colloidal, sputtered, and co...